Kyocera FS-1028MFP FS-1028MFP/1128MFP Operation Guide Rev-3 - Page 84
How to Load Originals, IMPORTANT, Ensure that loaded originals do not exceed
View all Kyocera FS-1028MFP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Preparation before Use How to Load Originals IMPORTANT: Before loading originals, be sure that there are no originals left on the original eject table. Originals left on the original eject table may cause the new originals to jam. 1 Adjust the original width guides to fit the originals. 2 Place the originals. Put the side to be scanned (or the first side of two-sided originals) face-up. Slide the leading edge into the document processor as far as it will go. IMPORTANT: Confirm that the original width guides exactly fit the originals. If there is a gap, readjust the original width guides. The gap may cause the originals to jam. Ensure that loaded originals do not exceed the level indicator. Exceeding the maximum level may cause the originals to jam (see the figure). Originals with punched holes or perforated lines should be placed in such a way that the holes or perforations will be scanned last (not first). 2-44 OPERATION GUIDE