Kyocera KM-1820 1820 Operation Guide (Advanced Edition) - Page 104
Advanced > Protocols > TCP/IP > IP Filters, Description, TCP/IP Port Number, Bi-directional Printing
View all Kyocera KM-1820 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Using COMMAND CENTER Advanced > Protocols > TCP/IP > IP Filters IP filters specify a host or network of hosts that are allowed to access the printing system. An entry should be a network number or host IP address. Up to 10 access list entries are allowed. When there are no entries, access is allowed to all hosts. To allow all hosts on network 192, enter 192.0.0.0 and 255.0.0.0. To allow one host 192.168.1.2, enter 192.168.1.2. The default mask 255.255.255.255 is assumed and subnet mask can be left blank. Advanced > Protocols > TCP/IP > Logical Printers Logical Printers allows you to use this machine as four virtual printers. Each logical printer can be used with either FTP, LPR, or IPP protocols. All printout to a non-existent port will be accomplished to Logical Printer1. Item TCP/IP Port Number Bi-directional Printing Start of Job Strings End of Job Strings Description Specifies the IP address for the logical printer as well as the TCP raw port number (9100, etc.). Conversion is applied to data that is input to the specified raw port in accordance with the designated logical printer. This port is invalid if it is given a port number that is the same as that of an already specified port (e.g. FTP or LPD). Enables or disables bi-directional printing using the TCP/IP raw port. If you turn this setting Off, all data received from the printer will be ignored. In order to have the data that is received from the printer returned to the client when printing with PostScript, PJL and other such commands, it is necessary to enable bi-directional printing. Specifies the character string sent to the printer before output directly to the output port (lp port). Specifies the character string if it is necessary to transmit the control code before printing. Specifies the character string sent to the printer after directly outputting to the output port (lp port). Specify a character string, if it is necessary, to send a control code after printing. ADVANCED OPERATION GUIDE 8-19