Kyocera KM-3530 2530/3530/4030 Operation Guide Rev 2C - Page 10

INSTALLATION PRECAUTIONS I Environmment CAUTION • Avoid placing the copier on or in locations which are unstable or not level. Such locations may cause the copier to fall down or fall over. This type of situation presents a danger of personal injury or damage to the copier • Avoid locations with humidity or dust and dirt. If dust or dirt become attached to the power plug, clean the plug to avoid the danger of fire or electrical shock • Avoid locations near radiators, heaters, or other heat sources, or locations near flammable items, to avoid the danger of fire • To keep the copier cool and facilitate changing of parts and maintenance, allow access space as shown below. Leave adequate space, especially around the rear cover, to allow air to be properly ventilated out of the copier • During copying, some ozone is released, but the amount does not cause any ill effect to one's health. If, however, the copier is used over a long period of time in a poorly ventilated room or when making an extremely large number of copies, the smell may become unpleasant. To maintain the appropriate environment for copy work, it is suggested that the room be properly ventilated. I Power supply/Grounding the copier WARNING • DO NOT use a power supply with a voltage other than that specified. Avoid multiple connections in the same outlet. These types of situations present a danger of fire or electrical shock • Plug the power cord securely into the outlet. If metallic objects come in contact with the prongs on the plug, it may cause a fire or electric shock. . • Always connect the copier to an outlet with a ground connection to avoid the danger of fire or electrical shock in case of an electric short. If an earth connection is not possible, contact your service representative 30c=>m1L1ef1t:3/16"/ 10=0>c3Fm9ro3n/8t:"/ Right: Rear: =>11 13/16"/30cm => 11 13/16"/30cm • Always use the caster stoppers to stabilize the copier once it is in place to keep it from moving and/or falling over and causing injury Other precautions • Adverse environmental conditions may affect the safe operation and performance of the copier. Install in an airconditioned room (recommended room temperature: around 68°F (20°C), humidity: around 65%RH) and avoid the following locations when selecting a site for the copier. . Avoid locations near a window or with exposure to direct sunlight. . Avoid locations with vibrations. . Avoid locations with drastic temperature fluctuations. . Avoid locations with direct exposure to hot or cold air. . Avoid poorly ventilated locations. Other precautions • Connect the power plug to the closest outlet possible to the copier. • The power supply cord is used as the main disconnect device. Ensure that the socket/outlet is located/installed near the equipment and is easily accessible. I Handling of plastic bags WARNING • Keep the plastic bags that are used with the copier away from children. The plastic may cling to their nose and mouth causing suffocation. ........ • If the copier is moved after installation, the flooring may be damaged by the casters depending on the flooring material. 1-2