Kyocera KM-3530 2530/3530/4030 Operation Guide Rev 2C - Page 124

CHAPTER 8 WHEN A PROBLEM OCCURS (1) Cautions WARNING High voltage is present in the charger section. Take sufficient care when working in this area, as there is a danger of electrical shock. CAUTION The copier's fixing unit is extremely hot. Take sufficient care when working in this area, as there is a danger of getting burned. • Do not reuse misfed paper. • If paper is torn during removal, be sure to remove all loose scraps from inside the copier, or they could cause misfeed later. • After misfed paper has been removed, warm-up will begin. The Misfeed indicator will turn off and the copier will return to the same settings prior to the misfeed. (2) Removal procedures 1 Misfeed in paper feed section • Misfeed in drawer (JAM 10 to 13, 15 to 17) If the message below appears, a misfeed has occurred in the drawer (or optional paper feeder). Remove the misfed paper using the procedure given below. Inch specifications 2 Remove the misfed paper while taking care not to tear it. * If the paper should be torn, remove all the scraps from the inside the copier. 3 Close the drawer slowly. * Check that the paper is kept under the claws of the drawer. If not, reload the paper. • Misfeed in left cover 1 (JAM 30 to 34, 36 to 52, 60, 61) If the message below appears, a misfeed has occurred in the left cover 1. Remove the misfed paper using the procedure given below. Inch specifications Metric specifications Metric specifications 1 Open the drawer. 1 Pull up the lock lever to open the left cover 1. 8-4