Kyocera TASKalfa 3050ci 3050ci/3550ci/4550ci/5550ci Operation Guide Rev-2.2011 - Page 176

Copying Functions The procedure for using Combine mode copying is explained below. 1 Press the Copy key. 2 Place the originals on the platen. 3 Press [Layout/Edit] and then [Combine]. Combine Off 2 in 1 4 in 1 Original Zoom Paper : A4 : 50% : A4 Preview Status Add Shortcut Copies Layout Right then Down Left then Down Down then Right Down then Left Cancel None Border Line Top Edge on Top Original Orientation OK 10/10/2010 10:10 4 Press [2 in 1] or [4 in 1], and choose the page layout of Layout. 5 Press [Border Line] to choose the type of the lines to indicate page boundaries. Press [OK]. 6 Press [Original Orientation] to choose the orientation of the originals, either [Top Edge on Top] or [Top Edge on Left]. Then press [OK]. 7 Press [OK]. 8 Press the Start key. Copying begins. If the original is placed on the platen, replace the original and press the Start key. After scanning all originals, press [Finish Scan] to start copying. Margin/Centering Shift the original image to make space on the copy for binding on the left (right) or top (bottom) side. When you copy onto paper different from the original size, you can center the original image on the paper. The following margin widths are available. Input units Inch Models Metric Models Margin Width -0.75 to 0.75" (in 0.01" increments) -18 mm to 18 mm (in 1-mm increments) Margin on the Back Side When duplex copying, you can also specify the margin on the back side. Auto When [Auto] is selected, an appropriate margin is applied automatically on the rear page depending on a margin specified for the front page and a binding orientation. Separate Front/Back Margins Enables you to specify the front and back settings separately. NOTE: You can set the default margin width. Refer to Margin Default on page 9-24 for details. 4-16