Kyocera TASKalfa 520i 420i/520i Operation Guide - Page 158

Copying Functions Repeat Copy Enable additional copies in the desired quantity as necessary after a copy job is completed. For confidential documents, you can set up a pass code for the use of Repeat Copy. In such a case, the correct pass code must be entered when using Repeat Copy or copies will not be delivered. IMPORTANT: A Repeat Copy job is cleared when the main power switch is turned off. Repeat Copy is not available when the machine is equipped with the optional Data Security Kit. Repeat Copy cannot be used when the maximum number of Repeat Copy jobs to retain in the document box is set to zero (refer to Maximum Number of Repeat Copy Jobs Retained on page 4-37). You can select Repeat Copy as default setting. Refer to Repeat Copying on page 8-23. Giving a file name to a copy job will facilitate identification of the data when copying (refer to File Name on page 4-35). Selecting Repeat Copy Use the procedure below to select repeat copying. Ready to copy. Repeat Copy Off Place original. On Original Zoom Paper : --: 100% : --- Preview Status Add Shortcut Copies Password(4digits) # Keys Cancel OK 08/08/2009 10:10 1 Press the Copy key. 2 Place the originals on the platen. 3 Press [Advanced Setup] and then [Repeat Copy]. 4 Press [On]. To register a password, press [# Keys] and enter a 4-digit password. IMPORTANT: If you forget the pass code, Repeat Copy will be unavailable. Make a note of the pass code beforehand if necessary. 5 Press [OK]. 6 Press the Start key to start copying and register this job as a Repeat Copy job. 4-36 OPERATION GUIDE