Kyocera TASKalfa 520i 420i/520i Operation Guide - Page 296
Network Setup, Checking Host Name, TCP/IP (IPv4) Setup
View all Kyocera TASKalfa 520i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 296 highlights
Default Setting (System Menu) Network Setup The following network settings are available. • Checking Host Name ...8-64 • TCP/IP (IPv4) Setup ...8-64 • TCP/IP (IPv6) Setup ...8-64 • Protocol Detail ...8-66 • NetWare Setup ...8-67 • AppleTalk Setup ...8-68 • WSD Scan Setup ...8-68 • WSD Print Setup ...8-68 • Secure Protocol ...8-69 • IPSec Setting ...8-71 • LAN Interface Setup ...8-71 Checking Host Name Check the host name of the machine. Use the procedure below. 1 Press the System Menu key. 2 Press [System], [Next] of Network. Check the host name displayed under Host Name. TCP/IP (IPv4) Setup Set up TCP/IP to connect to the Windows network. Refer to TCP/IP (IPv4) Setup (by Entering IP Addresses) on page 2-12 about the procedures. TCP/IP (IPv6) Setup Set up TCP/IP (IPv6) to connect to the network. The default settings are "TCP/IP Protocol: On, TCP/IP (IPv6): Off. Use the procedure below. 1 Press the System Menu key. 2 Press [System], [Next] of Network and then [Next] of TCP/IP Setting. 3 Press [Change] of TCP/IP. 4 Press [On] and then press [OK]. 5 Press [Next] of IPv6. 6 Press [Change] of IPv6. 7 Press [On]. IP Address (Link Local) appears. 8 Press [OK]. 9 After changing the setting, restart the system or turn the machine OFF and then ON again. For detailed information on restarting the system, refer to Restarting the System on page 8-63. 8-64 OPERATION GUIDE