Kyocera TASKalfa 520i 420i/520i Operation Guide - Page 50
Network Setup (LAN Cable Connection), TCP/IP (IPv4) Setup (by Entering IP Addresses)
View all Kyocera TASKalfa 520i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Preparation before Use Network Setup (LAN Cable Connection) The machine is equipped with network interface, which is compatible with network protocols such as TCP/IP (IPv4), TCP/IP (IPv6), IPX/SPX, NetBEUI, IPSec, and AppleTalk. It enables network printing on the Windows, Macintosh, UNIX, NetWare and other platforms. This section explains the TCP/IP (IPv4) Setup and AppleTalk Setup procedures. For other network settings, refer to the Network Setup on 8-64. • TCP/IP (IPv4) Setup...2-12 • AppleTalk Setup...2-14 NOTE: If user login administration is enabled, you can only change the settings by logging in with administrator privileges. If user login administration is disabled, the user authentication screen appears. Enter a login user name and password, and press [Login]. Refer to Adding a User on page 11-5 for the default login user name and password. TCP/IP (IPv4) Setup (by Entering IP Addresses) Set up TCP/IP to connect to the Windows network. Set the IP addresses, subnet masks, and gateway addresses. The default settings are "TCP/IP Protocol: On, DHCP: On, Bonjour: Off, Auto-IP: On". NOTE: Prior to the IP address entries, obtain permission from the network administrator. Use the procedure below. System - IPv4 Set TCP/IP (IPv4). IP Address Subnet Mask On Default Gateway 0.0.0.0 0.0.0.0 0.0.0.0 On DHCP Off Bonjour Status 1 Press the System Menu key. 2 Press [System], [Next] of Network and then [Next] of TCP/IP Setting. 3 Press [Change] of TCP/IP. 4 Press [On] and then press [OK]. 5 Press [Change] of IPv4. 6 Press [DHCP]. On Auto-IP Cancel OK 08/08/2009 10:10 7 Press [Off] of DHCP and then press [OK]. 8 Press [Bonjour]. 2-12 OPERATION GUIDE