LG GSA-H10L Installation Guide
LG GSA-H10L - 16x DVD±RW DL IDE Drive Cribe Manual
 |
UPC - 048231294829
View all LG GSA-H10L manuals
Add to My Manuals
Save this manual to your list of manuals |
LG GSA-H10L manual content summary:
- LG GSA-H10L | Installation Guide - Page 1
, connect the drive to this channel and set the jumper to MASTER. ❷ When two drives are connected, set one drive to MASTER and the other drive to SLAVE. If your operating system encounters interface problems after installing the new drive, try swapping the jumpers or move one drive to another IDE - LG GSA-H10L | Installation Guide - Page 2
is normally not required. ❷ Connect the IDE data cable to the back of the drive. ❸ Connect a 4-pin power supply cable from the computer to the drive. MarMkianrkgingLL-R-R Sound Card ❶ AAuuddiioo CCaabblele ❷ IDEECCaablbele D❸C DPoCweProCwabelre Cable Replace the cover, connect the power - LG GSA-H10L | Installation Guide - Page 3
Drive LightScribe GSA-H10L Supported GSA-H10N Not Supported Package Items Item - Internal Super Multi DVD Drive - Recording & Authoring Software [Nero, InCD, Power Producer, MPEG-2 Software (PowerDVD)] - E-IDE (ATAPI) cable - Audio Cable - Mounting Screws - Quick Set-up Guide for Super Multi DVD - LG GSA-H10L | Installation Guide - Page 4
sent guide vista LG. O uso dos controles ou a execução de procedimentos diferentes que não sejam os especificados neste manual DVD Drive is for use only with UL listed personal computers that have installation instructions detailing user-installation of card cage accessory. ■ Microsoft® and Windows
-
1 -
2 -
3 -
4
 |
 |
Before installing the drive, turn off
the system power.
Disconnect the power cord,
and remove the cover.
• Remove a vacant 5.25” drive bay panel from
the computer. Slide the drive into the drive
bay.
Set the jumper on the rear of
the drive as necessary.
A. When using a Primary IDE port
If you need to connect your drive to the same
primary IDE channel as the hard drive, the drive
should be set to SLAVE position.
B. When using a Secondary IDE port
❶
If there is no device connected to the
secondary IDE channel, connect the
drive to this channel and set the jumper
to MASTER.
❷
When two drives are connected, set one
drive to MASTER and the other drive to
SLAVE. If your operating system encounters
interface problems after installing the new
drive, try swapping the jumpers or move
one drive to another IDE channel.
Installing the Drive
Method A
Method B
Super Multi DVD Writer
Super Multi DVD Drive
First Drive
Second Drive