LG GSA-H55L Installation Instructions

LG GSA-H55L - 20x DVD±RW DL IDE Drive Cribe Manual

Get LG GSA-H55L - 20x DVD±RW DL IDE Drive Cribe PDF manuals and user guides
UPC - 683728151256
View all LG GSA-H55L manuals
Add to My Manuals
Save this manual to your list of manuals

LG GSA-H55L manual content summary:

  • LG GSA-H55L | Installation Instructions - Page 1
    system encounters interface problems after installing the new drive, try swapping the jumpers or move one drive to another IDE channel. Method A DAIGUDITIAOL AANUADLIOOG DG R G L CS M S LA 39 40 INTERFACE POWER 1 2 +5 GND +12 Super Multi DVD Rewriter Super Multi DVD Rewriter Method
  • LG GSA-H55L | Installation Instructions - Page 2
    DMA/32))'. In this case, substitute to 80-pin type IDE cable is highly recommended. This kind of error is hardly detected from some specific motherboard. ❷ Connect a 4-pin power supply cable from the computer to the drive. Reserved ❶ IIDDE CCaabblele D❷C DPoCweProCwaeblre Cable Replace the cover
  • LG GSA-H55L | Installation Instructions - Page 3
    Quick Set-up Guide Super Multi DVD Rewriter GSA-H55N GSA-H55L To install of your product, please read this guide manual carefully and completely. For the detailed owner's manual of the drive, please refer to the CD manual. Features • Enhanced-IDE (ATAPI) interface. • Power tray loading and
  • LG GSA-H55L | Installation Instructions - Page 4
    LG. O uso dos controles ou a execução de procedimentos diferentes que não sejam os especificados neste manual Super Multi DVD Rewriter is for use only with UL listed personal computers that have installation instructions detailing user-installation of card cage accessory. ■ Microsoft® and Windows
  • 1
  • 2
  • 3
  • 4
Before installing the drive, turn off
the system power.
Disconnect the power cord,
and remove the cover.
• Remove a vacant 5.25” drive bay panel from
the computer. Slide the drive into the drive
bay.
Set the jumper on the rear of
the drive as necessary.
A. When using a Primary IDE port
If you need to connect your drive to the same
primary IDE channel as the hard drive, the drive
should be set to SLAVE position.
B. When using a Secondary IDE port
❶
If there is no device connected to the
secondary IDE channel, connect the
drive to this channel and set the jumper
to MASTER.
❷
When two drives are connected, set one
drive to MASTER and the other drive to
SLAVE. If your operating system encounters
interface problems after installing the new
drive, try swapping the jumpers or move
one drive to another IDE channel.
Installing the Drive
Method A
Method B
Super Multi DVD Rewriter
Super Multi DVD Rewriter
Super Multi DVD Rewriter
First Drive
Second Recorder
Super Multi DVD Rewriter
Super Multi DVD Rewriter