LG GSA-H55N Owner's Manual (English)

LG GSA-H55N - LG Super-Multi Manual

Get LG GSA-H55N - LG Super-Multi PDF manuals and user guides
UPC - 048231297356
View all LG GSA-H55N manuals
Add to My Manuals
Save this manual to your list of manuals

LG GSA-H55N manual content summary:

  • LG GSA-H55N | Owner's Manual (English) - Page 1
    system encounters interface problems after installing the new drive, try swapping the jumpers or move one drive to another IDE channel. Method A DAIGUDITIAOL AANUADLIOOG DG R G L CS M S LA 39 40 INTERFACE POWER 1 2 +5 GND +12 Super Multi DVD Rewriter Super Multi DVD Rewriter Method
  • LG GSA-H55N | Owner's Manual (English) - Page 2
    -pin type IDE cable is highly recommended. This kind of error is hardly detected from some specific motherboard. ❷ Connect a 4-pin power supply cable from the computer to the drive. Reserved ❶ IIDDE CCaabblele D❷C DPoCweProCwaeblre Cable Replace the cover, connect the power cord and restart your
  • LG GSA-H55N | Owner's Manual (English) - Page 3
    a variety of Drive LightScribe GSA-H55L Supported GSA-H55N Not Supported Package Items Item - Internal Super Multi DVD Rewriter - Recording & Authoring Software [Nero, InCD, Power Producer, MPEG-2 Software (PowerDVD)] - Quick Set-up Guide for Drive Quantity 1 1 1 * For Optimal 18x, 20x writing
  • LG GSA-H55N | Owner's Manual (English) - Page 4
    the user's authority to operate the equipment. • This Super Multi DVD Rewriter is for use only with UL listed personal computers that have installation instructions detailing user-installation of card cage accessory. ■ Microsoft® and Windows® are trademarks registered in the United States and other
  • 1
  • 2
  • 3
  • 4
Before installing the drive, turn off
the system power.
Disconnect the power cord,
and remove the cover.
• Remove a vacant 5.25” drive bay panel from
the computer. Slide the drive into the drive
bay.
Set the jumper on the rear of
the drive as necessary.
A. When using a Primary IDE port
If you need to connect your drive to the same
primary IDE channel as the hard drive, the drive
should be set to SLAVE position.
B. When using a Secondary IDE port
❶
If there is no device connected to the
secondary IDE channel, connect the
drive to this channel and set the jumper
to MASTER.
❷
When two drives are connected, set one
drive to MASTER and the other drive to
SLAVE. If your operating system encounters
interface problems after installing the new
drive, try swapping the jumpers or move
one drive to another IDE channel.
Installing the Drive
Method A
Method B
Super Multi DVD Rewriter
Super Multi DVD Rewriter
Super Multi DVD Rewriter
First Drive
Second Recorder
Super Multi DVD Rewriter
Super Multi DVD Rewriter