LG LFC23760SW Owner's Manual - Page 14

Caution, Warning - refrigerator parts

Page 14 highlights

REFRIGERATOR INSTALLATION • With both hands, hold the center of the bar and push • Compare the left and right rail covers on each side. it in so that it is fit to both rails simultaneously. Right Rail Left Rail CAUTION: When removing the drawer, do not hold the handle. If it comes off, it could cause personal injury. CAUTION: To place the drawer on the floor, take care not to damage the floor or hurt your feet with the sharp edges on the side with the hinges. • Align the top holes of the rail cover with the top holes of the door supports to mount the cover. 2. Installing the Pull Out Drawer • With both hands, hold the center of the bar and pull it outward so that the two rails extend out at the same time. Verify the hole's alignment • Mount door supports (1) into the tabs on the railing track (2), starting in the back first and then connecting the part in the front last, as shown in the figure. 1 • With the drawer fully extended, insert the lower basket over the front part of the rail assembly and then the back part (4). 4 2 • Push the drawer down into position and tighten the screws (3). 3 WARNING: To prevent entrapment risk and accidental child or animal suffocation, DO NOT permit them to play inside of the drawer. WARNING: DO NOT step or sit on the Freezer Door. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31

13
REFRIGERATOR INSTALLATION
With both hands, hold the center of the bar and push
it in so that it is fit to both rails simultaneously.
CAUTION:
When removing the drawer, do not hold
the handle. If it comes off, it could cause personal
injury.
CAUTION:
To place the drawer on the floor, take
care not to damage the floor or hurt your feet with
the sharp edges on the side with the hinges.
2. Installing the Pull Out Drawer
With both hands, hold the center of the bar and pull it
outward so that the two rails extend out at the same
time.
Mount door supports (1) into the tabs on the railing
track (2), starting in the back first and then connecting
the part in the front last, as shown in the figure.
Push the drawer down into position and tighten the
screws (3).
Compare the left and right rail covers on each side.
Right Rail
Left Rail
Align the top holes of the rail cover with the top holes
of the door supports to mount the cover.
Verify the
hole’s alignment
With the drawer fully extended, insert the lower basket
over the front part of the rail assembly and then the
back part (4).
WARNING:
To prevent entrapment risk and
accidental child or animal suffocation, DO NOT
permit them to play inside of the drawer.
WARNING:
DO NOT step or sit on the Freezer
Door.
1
2
3
4