LG LFC25765ST Owner's Manual - Page 16

USING YOUR REFRIGERATOR ENSURING PROPER AIR CIRCULATION In order to obtain stable temperature, the air must flow between the freezer and refrigerator sections. As shown in the illustration below, the cold air enters through the bottom part and circulates upward. This air returns below the freezer floor and the rest of the air enters the refrigerator section through the top vent. MULTI FLOW • The cooling fan operates more powerful and effective than when in normal operation. This is especially noticeable when new food is placed in the refrigerator compartment. • If the lining is damaged, water or other substances could enter through the cool air vent causing decreased efficiency. ENERGY SAVING MODE NOTE: Energy-Saving Mode function is set from factory. To activate or deactivate Energy-Saving Mode, open the doors and then press the ENERGY SAVING button for 3 seconds. This function is recommended for added energy savings. (Some heaters to reduce excess moisture on the refrigerator may be turned off) The energy saving function is also recommended during long periods of time spent away from home-like vacation. CAUTION WHEN CLOSING THE DOOR CAUTION To reduce the risk of door scratches, please make sure that the refrigerator door mullion is always folded in. If dew gathers on the refrigerator door mullion at any point, deactivate the Energy Saving mode until the issue resolves itself. Do not block any of these vents with packages of food. This can interrupt the flow of air and cause temperature and moisture problems. IMPORTANT: Because air circulates between both sections, any odors formed in one section will transfer to the other. You must thoroughly clean both sections to eliminate odors. To prevent odor transfer and drying out of food, make sure you wrap or cover foods tightly (See the "Food Storage Guide" section for details). ICE PLUS Press the button ICE PLUS. The LED light will turn on. This function will remain activated for 24 hours and intensify the cooling speed of the freezer and increase ice production. ADJUSTING THE CONTROLS Your refrigerator has two controls that allow you to regulate the temperature the freezer and refrigerator compartments. Initially set the REFRIGERATOR CONTROL at 37° degrees F and the FREEZER CONTROL at 0° degrees F. Leave them at these setting for 24 hours (one day) to stabilize. Then adjust the compartment temperature as illustrated above. • Refrigerator Control: 32 °F to 47 °F (0 °C to 8 °C) To adjust the temperature in the refrigerator compartment open both doors, then press the REFRIGERATOR button to cycle through the range of available settings. DOOR ALARM With this feature you will hear an alarm when the freezer or refrigerator door is open for more than 1 minute. These tones will repeat every 30 seconds. The alarm is cancelled when the door is properly shut. To activate or deactivate Door Alarm, press the button ALARM. • Freezer Control: -6°F to 9 ° F ( - 21°C to -13°C) To adjust the temperature in the freezer compartment open both doors, then press the FREEZER button to cycle through the the range of available settings. • Temperature Display To change the temperature display from Fahrenheit to Celsius: 1. Simultaneously press and hold the FREEZER and REFRIGERATOR buttons for more than 5 seconds. 2. Do the same to convert back to Fahrenheit. 15