LG LFX31925ST Owner's Manual - Page 15

Assembling the Left Refrigerator Door - water line connector

Get LG LFX31925ST PDF manuals and user guides View all LG LFX31925ST manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

INSTALLATION 15 4 Make sure that the door-switch located inside the cover is tightly connected. Position the cover in its place. Insert and tighten the cover screw . 3 Connect all the wire harnesses. ENGLISH Assembling the Left Refrigerator Door Install the left refrigerator door after the right door is installed. 1 Make sure that the plastic sleeve is inserted in the bot- tom of the door. Install the refrigerator door onto the middle hinge. 4 Push the water supply tube into the hole on the top case and pull it through the backplate. 5 Hold the water supply connection and gently push in the collet to connect the water supply line as shown in and . Insert the tube at least 5/8 inch (15 mm) into the con- nector. Assemble the clip to the joint part for fastening. 2 Fit the hinge over the hinge lever latch and slot it into place. Rotate the lever clockwise and fasten the hinge. Collet Hinge Lever Latch

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
ENGLISH
15
INSTALLATION
4
Make sure that the door-switch located inside the cover
is tightly connected. Position the cover in its place. Insert
and tighten the cover screw
.
Assembling the Left Refrigerator Door
Install the left refrigerator door after the right door is installed.
1
Make sure that the plastic sleeve is inserted in the bot-
tom of the door. Install the refrigerator door onto the
middle hinge.
2
Fit the hinge
over the hinge lever latch and slot it into
place. Rotate the lever clockwise
and fasten the hinge.
3
Connect all the wire harnesses.
4
Push the water supply tube into the hole on the top case
and pull it through the backplate.
5
Hold the water supply connection and gently push in the
collet to connect the water supply line as shown in
and
. Insert the tube at least
5
/
8
inch (15 mm) into the con-
nector. Assemble the clip to the joint part for fastening.
Hinge Lever Latch
Collet