Lenovo IdeaCentre K330 Lenovo IdeaCentre K3 Series Hardware Maintenance Manual - Page 36

Replacing an optical drive

Get Lenovo IdeaCentre K330 PDF manuals and user guides View all Lenovo IdeaCentre K330 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

Hardware Maintenance Manual 4. Slide the new hard disk drive into the drive bay. 5. Pivot in the drive bay in place. 6. Connect the power and signal cables to the hard disk drive. Refer to "Identifying parts on the system board". 7. Refer to the "Completing the installation". Replacing an optical drive Attention Do not remove the computer cover or attempt any repair before reading the "Important safety information" in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://consumersupport.lenovo.com To replace an optical drive 1. Remove the computer cover. Refer to "Removing the computer cover". 2. Remove the front bezel. Refer to "Removing the front bezel". 3. Disconnect the data and power cables from the rear of the optical drive. 34

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
Hardware Maintenance Manual
34
4.
Slide the new hard disk drive into the drive bay.
5.
Pivot in the drive bay in place.
6.
Connect the power and signal cables to the hard disk drive. Refer to
“Identifying parts on the system board”.
7.
Refer to the “Completing the installation”.
Replacing an optical drive
Attention
Do not remove the computer cover or attempt any repair before
reading the “Important safety information” in the
Safety and Warranty
Guide
that was included with your computer or in the
Hardware
Maintenance Manual
(HMM) for the computer. To obtain copies of the
Safety and Warranty Guide
or
HMM
, go to the Support Web site at
To replace an optical drive
1.
Remove the computer cover. Refer to “Removing the computer cover”.
2.
Remove the front bezel. Refer to “Removing the front bezel”.
3.
Disconnect the data and power cables from the rear of the optical
drive.