Lenovo IdeaCentre K330 Lenovo IdeaCentre K3 Series Hardware Maintenance Manual - Page 53

Completing the installation

Get Lenovo IdeaCentre K330 PDF manuals and user guides View all Lenovo IdeaCentre K330 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 53 highlights

Chapter 7. Replacing hardware 4. Disconnect the failing speaker cable from the computer and connect the new speaker cable to the same connector. Completing the installation After replacing the parts, you need to close the computer cover and reconnect cables, including telephone lines and power cords. Also, depending on the part that was replaced, you might need to confirm the updated information in the Setup Utility program. Refer to "Starting the Setup Utility" in the User Guide or in the Hardware Maintenance Manual. To complete the part installation: 1. Ensure that all components have been reassembled correctly and that no tools or loose screws are left inside your computer. Refer to "Locating components" for the location of the various components. 2. Make sure that the cables are routed correctly before replacing the computer cover. 3. Position the computer cover on the chassis so that the rail guides on the bottom of the computer cover engage the rails. Then, push the computer cover closed until it snaps into position. 51

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
Chapter 7. Replacing hardware
51
4.
Disconnect the failing speaker cable from the computer and connect
the new speaker cable to the same connector.
Completing the installation
After replacing the parts, you need to close the computer cover and
reconnect cables, including telephone lines and power cords. Also,
depending on the part that was replaced, you might need to confirm the
updated information in the Setup Utility program. Refer to “Starting the
Setup Utility” in the
User Guide
or in the
Hardware Maintenance Manual
.
To complete the part installation:
1.
Ensure that all components have been reassembled correctly and
that no tools or loose screws are left inside your computer. Refer to
“Locating components” for the location of the various components.
2.
Make sure that the cables are routed correctly before replacing the
computer cover.
3.
Position the computer cover on the chassis so that the rail guides on
the bottom of the computer cover engage the rails. Then, push the
computer cover closed until it snaps into position.