Lenovo ThinkServer RD330 MegaRAID SAS Software User Guide - Page 307
Automatic, Manual, Start, Patrol Read, Disabled, Virtual Drives, Add >, Add All >>, Patrol
View all Lenovo ThinkServer RD330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 307 highlights
MegaRAID SAS Software User Guide Chapter 9: Monitoring System Events and Storage Devices | Running a Patrol Read Figure 190: Patrol Read Configuration 3. Select a mode for a patrol read. The options are: - Automatic: Patrol read runs automatically at the time interval you specify on this screen. - Manual: Patrol read runs only when you manually start it by selecting Start Patrol Read from the controller Options panel. - Disabled: Patrol read does not run. 4. Specify a maximum count of drives to include in the patrol read. The count must be from 1 to 255. 5. Click virtual drives in the list under the heading Virtual Drives to include in the patrol read and click Add > or click Add All >> to include all of the virtual drives. 6. (Optional) Change the frequency at which the patrol read will run. The default frequency is weekly (168 hours), which is suitable for most configurations. The other options are hourly, daily, and monthly. NOTE: We recommend that you leave the patrol read frequency and other patrol read settings at the default values to achieve the best system performance. If you decide to change the values, record the original default value here so you can restore them later, if necessary: Patrol Read Frequency Continuous Patrolling: Enabled/Disabled Patrol Read Task Rate 7. (Optional) Set Patrol Read to run at a specific time. The default is for the patrol read to start when you click OK on this screen. To change the default so that the patrol read starts at a specific time, follow these steps (otherwise, skip this step and proceed to the next step): Page 307