Home » Lexmark Manuals » Multifunction Devices » Lexmark 2500 » Manual Viewer

Lexmark 2500 User's Guide - Page 74

Trademarks, Conventions, Federal Communications Commission (FCC) compliance information statement

UPC - 734646093309

Add to My Manuals
Save this manual to your list of manuals

Page 74 highlights

Trademarks Lexmark and Lexmark with diamond design are trademarks of Lexmark International, Inc., registered in the United States and/or other countries. All other trademarks are the property of their respective owners. Conventions Note: A Note identifies something that could help you. Warning-Potential Damage: A Warning identifies something that could damage your product hardware or software. CAUTION-POTENTIAL INJURY: A CAUTION identifies something that could cause you harm. CAUTION-DO NOT TOUCH: This type of CAUTION indicates that you should not touch the marked area. CAUTION-HOT SURFACE: This type of CAUTION indicates a hot surface. CAUTION-SHOCK HAZARD: This type of CAUTION indicates a shock hazard. CAUTION-TIPPING HAZARD: This type of CAUTION indicates a tipping hazard. Federal Communications Commission (FCC) compliance information statement This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The FCC Class B limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult your point of purchase or service representative for additional suggestions. The manufacturer is not responsible for radio or television interference caused by using other than recommended cables or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could void the user's authority to operate this equipment. Note: To assure compliance with FCC regulations on electromagnetic interference for a Class B computing device, use a properly shielded and grounded cable such as Lexmark part number 1021294 for USB attach. Use of a substitute cable not properly shielded and grounded may result in a violation of FCC regulations. Notices 74

Section	Page
Contents	3
Finding information about the printer	7
Setting up the printer	11
Checking the box contents	11
Learning about the printer	12
Understanding the parts of the printer	12
Using the control panel buttons	14
Learning about the software	15
Using the printer software	15
Using the Lexmark Imaging Studio	15
Using the Solution Center	17
Using Print Properties	18
Opening Print Properties	18
Using the Save Settings menu	18
Using the I Want To menu	18
Using the Options menu	18
Using the Print Properties tabs	19
Using the Toolbar	19
Resetting printer software settings to defaults	20
Loading paper and original documents	21
Loading paper	21
Loading various paper types	21
Loading original documents on the scanner glass	24
Printing	26
Changing the paper type	26
Printing a document	26
Printing a Web page	26
Printing high-quality graphics	27
Printing photos or images from a Web page	27
Printing collated copies	28
Printing the last page first (reverse page order)	28
Printing on both sides of the paper (duplexing)	29
Printing transparencies	29
Printing envelopes	29
Printing iron-on transfers	30
Printing cards	30
Printing multiple pages on one sheet	31
Working with photos	32
Retrieving and managing photos	32
Transferring all photos from a media device using the computer	32
Transferring selected photos from a media device using the computer	32
Printing photos using the computer	33
Printing photos from the Photo Library	33
Printing all photos from a media device using the computer	33
Printing selected photos from a media device using the computer	33
Printing Photo Packages	34
Creating photo projects	34
Creating Photo Greeting Cards	34
Creating and viewing a slideshow	35
Printing an image as a multiple-page poster	35
Copying	37
Copying using the control panel	37
Making a copy	37
Copying 4 x 6 photos	37
Copying using the computer	38
Copying a document using the computer	38
Copying a photo using the computer	39
Scanning	40
Scanning using the control panel	40
Scanning using the computer	41
Scanning a document using the computer	41
Scanning a photo to the Photo Library	41
Scanning multiple photos at one time using the computer	42
Scanning multiple photos using the computer	42
Scanning documents or images for e-mailing	43
Saving a scanned image on the computer	44
Removing image patterns from photos, magazines, or newspapers	44
Customizing scan settings using the computer	45
Changing the order of programs in the Scan Application list	45
Faxing	46
Sending a fax using the software	46
Receiving a fax using the software	47
Using the computer Phone Book	47
Printing fax activity reports	47
Blocking junk faxes	48
Customizing fax settings	48
Customizing settings using the Fax Solution Software	48
Setting the number of rings before receiving a fax automatically	49
Maintaining the printer	50
Changing print cartridges	50
Removing a used print cartridge	50
Installing print cartridges	50
Achieving better print quality	52
Improving print quality	52
Aligning the print cartridges	52
Cleaning the print cartridge nozzles	53
Wiping the print cartridge nozzles and contacts	54
Preserving the print cartridges	55
Cleaning the scanner glass	55
Ordering print cartridges	55
Ordering paper and other supplies	56
Using genuine Lexmark print cartridges	56
Refilling a print cartridge	57
Recycling Lexmark products	57
Troubleshooting	58
Setup troubleshooting	58
Power button is not lit	58
Software does not install	58
Page does not print	59
Print troubleshooting	60
Improving print quality	61
Poor text and graphic quality	61
Poor quality at the edges of the page	62
Print speed is slow	62
Partial document or photo prints	63
Photo smudges	63
Copy troubleshooting	63
Copier does not respond	63
Scanner unit does not close	63
Poor copy quality	64
Partial document or photo copies	64
Scan troubleshooting	64
Scanner does not respond	65
Scan was not successful	65
Scanning takes too long or freezes the computer	65
Poor scanned image quality	66
Partial document or photo scans	66
Fax troubleshooting	66
Cannot send or receive a fax	66
Can send but not receive faxes	67
Can receive but not send faxes	67
Printer receives a blank fax	67
Received fax has poor print quality	68
Jams and misfeeds troubleshooting	68
Paper jams	68
Paper or specialty media misfeeds	68
Printer does not feed paper, envelopes, or specialty media	69
Banner paper jams	69
Blinking lights on the control panel	70
Error messages	71
Removing and reinstalling the software	72
Notices	73
Edition notice	73
UNITED STATES GOVERNMENT RIGHTS	73
Trademarks	74
Conventions	74
Federal Communications Commission (FCC) compliance information statement	74
European Community (EC) directives conformity	75
Noise emission levels	75
Waste from Electrical and Electronic Equipment (WEEE) directive	76
Federal Communications Commission (FCC) compliance information statement	76
Notice to users of the Canadian telephone network	77
Notice to users of the New Zealand telephone network	78
South Africa telecommunications notice	78
Power consumption	79
Product power consumption	79
Total energy usage	79
End-user license agreement	80

Match case Limit results 1 per page

Trademarks

Lexmark and Lexmark with diamond design are trademarks of Lexmark International, Inc., registered in the United

States and/or other countries.

All other trademarks are the property of their respective owners.

Conventions

Note:

Note

identifies something that could help you.

Warning—Potential Damage:

Warning

identifies something that could damage your product hardware or

software.

CAUTION—POTENTIAL INJURY:

CAUTION

identifies something that could cause you harm.

CAUTION—DO NOT TOUCH:

This type of

CAUTION

indicates that you should

not touch

the marked area.

CAUTION—HOT SURFACE:

This type of

CAUTION

indicates a

hot surface

CAUTION—SHOCK HAZARD:

This type of

CAUTION

indicates a

shock hazard

CAUTION—TIPPING HAZARD:

This type of

CAUTION

indicates a

tipping hazard

Federal Communications Commission (FCC) compliance information

statement

This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of

the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference,

and (2) this device must accept any interference received, including interference that may cause undesired operation.

The FCC Class B limits are designed to provide reasonable protection against harmful interference when the

equipment is operated in a residential installation. This equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult your point of purchase or service representative for additional suggestions.

The manufacturer is not responsible for radio or television interference caused by using other than recommended

cables or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could

void the user's authority to operate this equipment.

Note:

To assure compliance with FCC regulations on electromagnetic interference for a Class B computing device,

use a properly shielded and grounded cable such as Lexmark part number 1021294 for USB attach. Use of a substitute

cable not properly shielded and grounded may result in a violation of FCC regulations.

Notices