Lexmark C950 Service Manual - Page 310

5058-030 While this test runs, [Selected Output Bin] Feeding...appears on the LCD. During Single tests, no buttons are active. However, during Continuous tests, you can press Stop to cancel the test. Feed To All Bins This test is used to verify that the device can feed media to all installed output destinations. No information is printed on the feed test pages since the printhead LED is not engaged during this test. PRINT TESTS This menu's settings enable a user to test the device's ability to generate printed output from each of its installed input sources and to test the device's current print quality. [Input Source] Print Test After a user selects an input source to test, the panel displays two testing options: Single or Continuous. A Single test feeds one sheet of media from the selected input and prints a test page on it; the Continuous test continuously feeds media from the selected input and prints test pages until the user presses Stop. During a Single test, none of the panel's buttons are active while the test page prints. To run this test: 1. From the Diagnostics Menu, navigate to PRINT TESTS. 2. Select the input source from the following choices: • Tray 1 • Tray 2 • Tray 3 • Tray 4 • Multi-Purpose Feeder) 3. Touch either Single or Continuous. • Single-Feeds one sheet of media from the selected source. • Continuous-Media continues feeding from the selected source until Stop is pressed. Print Quality Pages (Diagnostics Menu) This setting enables a user to view the values of a broad range of the device's settings and to test the device's ability to generate acceptable printed output. PRINTER SETUP Configuration ID This setting enables a user to change both Configuration ID 1 and Configuration ID 2. Mono and Color Page Count The values of these settings enable a user to gauge the amount and type of usage on a device. The Mono Page Count setting's value will equal the value of the Picked Sides meter. The Color Page Count setting's value will equal the value of the Total Color sub-meter within the Imaged Printed Sides meter. Parallel Strobe Adjustment (all parallel ports) This setting enables the user to adjust the amount of time the strobe is sampled in order to determine if valid data is available on the parallel port. Each time this value is incremented by 1, the strobe is sampled 50 nanoseconds longer. Each time this value is decreased by 1, the strobe is sampled 50 nanoseconds less. When the value of this setting is 0, the factory default value is used to determine the length of time the strobe is sampled. 3-22 Service Manual Previous Next Go Back