Lexmark C950 Service Manual - Page 311

5058-030 To change this setting: 1. From the Diagnostics Menu, navigate to PRINTER SETUP. 2. Select Par 1 Strobe Adj. 3. Touch or to change the value. 4. Touch Submit to save the setting, or touch Back to return to the Diagnostics Menu without saving any changes. Previous Next Permanent Page Count The value of this setting indicates the total number of pages that have been printed by the device. Go Back Reset Color Calibration This setting enables the device to adjust the alignment of its color planes using pre-programmed default values. Using this setting to adjust color plane linearization may not provide a calibration as effective as using Automatic Color Adjust Calibration. While this text executes, the panel posts Resetting. Serial Number This setting records the device's 13-character (last character is a null value) serial number that was assigned by manufacturing. U.S. / Non-U.S. Defaults The value of this setting determines whether the device uses the U.S. or Non-U.S. factory default value. To change this setting: 1. From the Diagnostics Menu, navigate to PRINTER SETUP. 2. Select Defaults. 3. Touch or to change the value. 4. Touch Submit to save the setting, or touch Back to return to the Diagnostics Menu without saving any changes. REPORTS This menu contains informational reports that are helpful when servicing a device. The Menu Settings Page report generates a list of the Diagnostic Menu settings and each setting's current value. SENSOR TESTS PRINTER SENSOR TESTS This test verifies that the sensors in the base machine are operating properly. To run these tests: 1. From the Diagnostics Menu, navigate to SENSOR TESTS. 2. Select PRINTER SENSOR TESTS. 3. Select the test from the following options: Available tests: • Sensor (transparency detect) • Sensor (transfer belt HP) • Sensor (MPF media level) • Sensor (upper redrive) Diagnostic aids 3-23