Lexmark C950 Service Manual - Page 54

5058-030 User status and attendance messages User primary message Explanation Load Manual Feeder with [size] Try one or more of the following: • Load the specified paper in the multipurpose feeder. • Touch Prompt each page, paper loaded to clear the message and continue printing. If the printer finds a tray that has the correct paper type and size, then it feeds from that tray. If the printer cannot find a tray with the correct paper type and size, then it prints from the default paper source. • Cancel the print job. Load Manual Feeder with [paper type] [paper size] Try one or more of the following: • Load the specified paper in the multipurpose feeder. • Touch Prompt each page, paper loaded to clear the message and continue printing. If the printer finds a tray that has the correct paper type and size, then it feeds from that tray. If the printer cannot find a tray with the correct paper type and size, then it prints from the default paper source. • Cancel the print job. Load staples Try one or more of the following: • Replace the specified staple cartridge in the finisher. • Touch Continue to clear the message and continue printing. • Touch Cancel job to cancel the print job. Manual feeder expects [paper size]. Check [paper source] guides Try one or more of the following: • Load the specified paper size in the manual feeder. • Physically adjust [paper source] guides to a recognized paper size. • Touch Continue to clear the message and continue printing. If the printer finds a tray that has the correct paper type and size, then it feeds from that tray. If the printer cannot find a tray with the correct paper type and size, then it prints from the default source. Power off, wait 2 seconds, power on Turn the printer off and wait for 2 seconds before turning the printer back on. Print quota exceeded. The print job has been cancelled because the print quota has been exceeded. Print job canceled. Contact your system support person. Print quota exceeded. The print job did not complete because the print quota has been exceeded. Print job incomplete. Contact your system support person. Remove paper from standard output bin Remove the stack of paper from the standard exit bin. Remove paper from bin [x] Remove the paper from the specified bin. The printer automatically senses paper removal and resumes printing. If removing the paper does not clear the message, then touch Continue. Remove paper from [linked bin set name] Remove paper from all bins Remove the paper from the specified bin. The printer automatically senses paper removal and resumes printing. If removing the paper does not clear the message, then touch Continue. Remove the paper from all of the bins. The printer automatically senses paper removal and resumes printing. If removing the paper does not clear the message, then touch Continue. Restore Held Jobs? Some held jobs were not restored Unsupported disk Try one or more of the following: • Touch Continue to restore all held jobs stored on the printer hard disk. • Touch Do not restore if you do not want any print jobs to be restored. Touch Continue to delete the specified job. Note: Held jobs that are not restored stay on the hard disk and are inaccessible. An unsupported printer hard disk has been installed. Remove the unsupported device, and then install a supported one. 2-6 Service Manual Previous Next Go Back