Lexmark E360 Maintenance Guide
Lexmark E360 Manual
 |
View all Lexmark E360 manuals
Add to My Manuals
Save this manual to your list of manuals |
Lexmark E360 manual content summary:
- Lexmark E360 | Maintenance Guide - Page 1
Lexmark E360d and E360dn Series Maintenance Guide January 2010 www.lexmark.com - Lexmark E360 | Maintenance Guide - Page 2
3 Ordering supplies...4 Ordering toner cartridges ...4 Ordering a photoconductor kit ...5 Replacing supplies...5 Replacing the toner cartridge ...5 Replacing the photoconductor kit ...6 Moving the printer...9 Before moving the printer ...9 Moving the printer to another location...9 Shipping - Lexmark E360 | Maintenance Guide - Page 3
all cables to the printer before proceeding. 2 Remove all paper from the printer. 3 Dampen a clean, lint‑free cloth with water. Warning-Potential of the printer, print a network setup page and locate the IP address in the TCP/IP section. 2 Click Device Status. The Device Status page appears, - Lexmark E360 | Maintenance Guide - Page 4
area. In other countries or regions, visit the Lexmark Web Site at www.lexmark.com or contact the place where you purchased the printer. Note: All life estimates for printer supplies assume printing on letter‑ or A4‑size plain paper. Ordering toner cartridges When 88 Cartridge is Low appears or when - Lexmark E360 | Maintenance Guide - Page 5
see the status of the photoconductor kit by printing a network setup page. Part name Photoconductor kit Part number E260X22G Replacing supplies Replacing the toner cartridge When 88 Cartridge is low appears, or when you experience faded print, remove the toner cartridge. Firmly shake it side‑to - Lexmark E360 | Maintenance Guide - Page 6
toner cartridge in as far as it will go. The cartridge clicks into place when correctly installed. 6 Close the front door. Replacing the photoconductor kit The printer automatically notifies you before the photoconductor kit reaches a page maximum by showing 84 PC Kit life warning or 84 Replace PC - Lexmark E360 | Maintenance Guide - Page 7
by pressing the button on the left side of the printer and lowering the front door. 3 Pull the photoconductor kit and toner cartridge out of the printer as a unit by pulling on the toner cartridge handle. Note: The photoconductor kit and toner cartridge form a unit. Place the unit on a flat, clean - Lexmark E360 | Maintenance Guide - Page 8
the photoconductor drum. Doing so may affect the print quality of future print jobs. 6 Insert the toner cartridge into the photoconductor kit by aligning the rollers on the toner cartridge with the tracks. Push the toner cartridge until it clicks into place. 7 Install the unit into the printer by - Lexmark E360 | Maintenance Guide - Page 9
the photoconductor kit, reset the photoconductor counter. To reset the photoconductor counter, open the front door, press and hold until Resetting PC Counter appears. The power light blinks, and the printer beeps. Warning-Potential Damage: Resetting the photoconductor counter without replacing the
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
 |
 |
Lexmark E360d and E360dn Series
Maintenance Guide
January 2010
www.lexmark.com