Lexmark E360d Service Manual - Page 118
Install the two screws holding the new solenoid in place
View all Lexmark E360d manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
4513-420, -430 6. Lift the left door mount (C) away from the side frame, and unroute the cable (D) with a spring hook. 7. Reinstall the left door mount, and place the printer on it's top. Note: Be careful to not mar the finish of the printer. 8. Disconnect the cable (D) from J25 on the controller board, and remove the manual feed solenoid. Installation note: Install the two screws holding the new solenoid in place, and route the cable (D) behind the MPF clutch (E). DE C 4-36 Lexmark™ E360d, E360dn
4-36
Lexmark™ E360d, E360dn
4513-420, -430
6.
Lift the left door mount (C) away from the side frame, and unroute the cable (D) with a spring hook.
7.
Reinstall the left door mount, and place the printer on it’s top.
Note:
Be careful to not mar the finish of the printer.
8.
Disconnect the cable (D) from J25 on the controller board, and remove the manual feed solenoid.
Installation note:
Install the two screws holding the new solenoid in place, and route the cable (D) behind the MPF clutch (E).
E
C
D