Lexmark E360d Service Manual - Page 42
-430, Fan service errors, Error, Description, Action, Fuser service check, - e360dn toner cartridge
View all Lexmark E360d manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
4513-420, -430 Error Description Action 922.05 Did not roll over to a steady state control in time after the Replace the fuser. See "Fuser service check" hot roll lamp detection. on page 2-25. 922.06 922.07 Hot roll did not reach the operating temperature in time (new enhanced control). Media reached fuser nip, and fuser is under temperature 922.08 Fuser warm-up failure (motor start condition) 922.09 922.20 Fuser warm-up failure (compression set) Belt fuser failed to reach the preheat temperature for the motor to start during warm-up. 922.21 Belt fuser was under temperature when the media reached the fuser nip. 923.00 Fuser is over temperature. 923.01 924.00 Fuser is over temperature. This applies to the fuser and belt fusers. Open thermistor check. 924.01 924.02 925.xx Open thermistor check failure. This applies to the fuser and belt fusers. Open thermistor check failure. The ADC failed to converge. Possible noisy thermistor signal. This applies to the fuser and belt fusers. Wrong fuser installed. The fuser type stored in the cartridge ID does not match the actual fuser installed in the printer. Fan service errors 927.00 Service fan error 927.03 Main fan took too long to ramp up 927.04 Main fan is under speed or stalled during speed adjustment state Replace the fan. See "Cooling fan service check" on page 2-23. 927.05 927.06 Main fan overspeed during speed adjustment state. Main fan capture data is invalid, and speed control is at maximum in fan control idle state 927.07 Main fan capture data is invalid, and speed control is at maximum in fan control adjustment state. Toner service errors 929.00 929.01 929.02 Toner sensor error No home window No sensor transition (closed) Remove the toner cartridge, and shake it Try a different toner cartridge, if possible. If the error persists, then replace the toner level sensor. See "Toner level sensor removal" on page 4-60. 929.03 No sensor transition (open) Printhead service errors 930.00 Wrong printhead installed 931.00 No first hsync Replace the printhead. See "Printhead service check" on page 2-37. 2-16 Lexmark™ E360d, E360dn