Lexmark P6250 Setup Sheet
Lexmark P6250 Manual
View all Lexmark P6250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Lexmark P6250 manual content summary:
- Lexmark P6250 | Setup Sheet - Page 1
in the print cartridge storage unit: 2 Place the stored cartridge in the storage area of your All-In-One. 1 2 3 3 2 You may discard the alignment page after it prints. If you are using your All-In-One with a computer, continue with "Install the software"... Lexmark Confidential until - Lexmark P6250 | Setup Sheet - Page 2
, or contact the software manufacturer for support. Important: After installation is complete, remember to re-enable your anti-virus software. 3 Insert the CD. Setup troubleshooting Need more ink? Symptom The Power light is not lit Software will not install The control panel displays
Note:
Contents may vary.
6200 Series All-In-One
Lift the paper support and
extend the paper exit tray.
Load plain paper.
*21B0070*
•
Use only the power supply provided
with this product or the manufacturer's
authorized replacement power supply.
•
Connect the power supply cord to an
electrical outlet that is near the product
and easily accessible.
•
Refer service or repairs, other than
those described in the user
documentation, to a professional
service person.
CAUTION:
Do not use the fax feature
during a lightning storm. Do not set up this
product or make any electrical or cabling
connections, such as the power supply
cord or telephone, during a lightning
storm.
Open the cartridge lids, insert the cartridges, and
snap
the lids closed.
1
2
3
Left:
Right:
Lower the paper feed guard,
squeeze the paper guide, and
slide it to the left edge of the paper.
3
2
1
Connect the power cord.
2
1
Make sure the
Power light is
on.
1
Prepare your All-In-One
2
1
Load paper
2
3
Unpack your All-In-One
2
Install the print cartridges
3
Close the scanner unit.
1
3
2
Press the right arrow button
to scroll to your language,
and then press
Select
.
2
1
3
4
Press
Select
to print an
alignment page.
You may discard the
alignment page after it
prints.
Place the stored cartridge
in the storage area of your
All-In-One.
Keep a new or
partially used
cartridge in the
print cartridge
storage unit:
1
2
Cartridge storage
1
2
3
4
Prepare the print cartridges
Remove the sticker and tape from the print cartridges.
Warning:
Do not touch the copper contact area on
the back or the metal print cartridge nozzles on the
bottom.
2
1
1
2
1
2
Remove the photo
cartridge from the
print cartridge storage
unit.
Lift the scanner unit.
1
5
Safety Information
If you are using your
All-In-One with a computer,
continue with “Install the
software”...