Lexmark X342N Service Manual - Page 120
Scanner flatbed cover removal, Scanner top removal, Rear cover removal
UPC - 734646256292
View all Lexmark X342N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
7003-XXX Scanner flatbed cover removal 1. Remove the rear cover. See"Rear cover removal" on page 4-5. 2. Disconnect the ADF cable from J3 on the controller card. 3. Lift and remove the flatbed cover from the MFP. Scanner top removal 1. Remove rear cover. See "Rear cover removal" on page 4-5. 2. Open the lower right cover, and disconnect the ADF cable from J3 on the controller card. 3. Remove flatbed cover. 4. Remove operator panel. Go to "Operator panel assembly removal" on page 4-30. 5. Remove three screws (A) on the front of the scanner top. 6. Remove two screws (B) located on the rear of the scanner top. 7. Remove the scanner top. 4-48 Service Manual manuals4you.com
4-48
Service Manual
7003-XXX
Scanner flatbed cover removal
1.
Remove the rear cover. See
“Rear cover removal” on page 4-5
.
2.
Disconnect the ADF cable from J3 on the controller card.
3.
Lift and remove the flatbed cover from the MFP.
Scanner top removal
1.
Remove rear cover. See
“Rear cover removal” on page 4-5
.
2.
Open the lower right cover, and disconnect the ADF cable from J3 on the controller card.
3.
Remove flatbed cover.
4.
Remove operator panel. Go to
“Operator panel assembly removal” on page 4-30
.
5.
Remove three screws (A) on the front of the scanner top.
6.
Remove two screws (B) located on the rear of the scanner top.
7.
Remove the scanner top.
manuals4you.com
manuals4you.com