Lexmark X342N Service Manual - Page 39
A4, oversized paperfeed service check on Paper jam near Tray 2 - manual for 202 13 paper jams
UPC - 734646256292
View all Lexmark X342N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
7003-XXX Sub error codes (Continued) First 6 bytes sub error code data (xx can be any value) 89 00 01 8E xx 09 x1 8E xx 08 84 xx 2D 8E xx 11 8E xx 10 8E xx 09 x1 8E xx 08 8E xx 09 x1 8E xx 08 84 xx 3B Explanation Possible error message The exit sensor at the fuser is activated by a piece of media indicating there is a piece of media in the machine during POST. Check for media in the exit of the fuser assembly or redrive assembly. Feed a sheet of paper, and if the same error occurs after clearing the fuser or the same error occurs when no media is present, check the exit sensor assembly. 202.13 Paper jam near Tray 1 241.00 The second pick from the MPF or Tray 1 failed when other sheets were committed to the paper path. (x1=media source) 241.12 Failure to feed from Tray 1. Pages in the paper path have been flushed to 241.16 the output bin. Misidentified no gap jam. Engine detected no gap at the at the manual feed sensor. An attempt was made to open the gap by stopping the feed rolls. A trailing edge was seen at the input sensor. The manual feeder sensor is no longer covered. Go to "A4, oversized paperfeed service check" on page 2-30. 241.18 Paper jam near Tray 2 242.00 Took too long to ramp up DC feed motor 242.01 Received lots of DC interrupts before losing them 242.08 The second pick from the MPF or Tray 1 failed when other sheets were committed to the paper path. (x1=media source) 242.12 Failure to feed from Tray 2. Pages in the paper path have been flushed to 242.16 the output bin. Paper jam near manual feeder. 251.00 The second pick from the MPF or Tray 1 failed when other sheets were committed to the paper path. (x1=media source) 251.12 Failure to feed from Tray 1. Pages in the paper path have been flushed to 251.11 the output bin. Paper never reached the input sensor from the manual feeder. Possible cause: Defective input sensor 251.19 Diagnostic information 2-17