Lexmark X925 Print Defects Guide

Print defects guide

Repeating defects measurements

Match a set of repeating defects on a print job to the marks on one of the vertical lines. The line that best matches the defects

on the print job indicates which particular part is causing the defect.

Note:

Make sure the current selection in the printer for Scale to Fit in the PDF menu is set to No for the rulers to be printed at

the correct size.

Change the imaging unit if the repeating defects appear in these

instances:

•

every 41 mm (1.61 inches) of the page

•

every 75 mm (2.95 inches) of the page

Note:

The printer has four imaging units. Replace the imaging

unit that has the same color as the repeating print defect.

Change the fuser if repeating

defects appears on every

141 mm (5.55 inches) of the

printed page.

Change the transfer module if

repeating defects appears on

every 38 mm (1.5 inches) of the

printed page.

Print defects guide

Page 1 of 1