LiftMaster 3595 3595 Elite Series Manual

LiftMaster 3595 Manual

Get LiftMaster 3595 PDF manuals and user guides View all LiftMaster 3595 manuals
Add to My Manuals
Save this manual to your list of manuals

LiftMaster 3595 manual content summary:

  • LiftMaster 3595 | 3595 Elite Series Manual - Page 1
    www.liftmaster.com ® GARAGE DOOR OPENER Model 3595 3/4 HP For Residential Use Install on Sectional Doors ONLY THIS OPERATOR IS INTENDED FOR USE ONLY WITH I-BEAM RAILS. Owner's Manual ■ Please read this manual and the enclosed safety materials carefully! ■ Fasten the manual near the garage door after
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 2
    Entry PIN 30 Repair Parts 31-32 Rail assembly parts 31 Installation parts 31 Motor unit assembly parts 32 Accessories 33 Notes 34-35 Repair Parts and Service 36 Warranty 36 INTRODUCTION Safety Symbol and Signal Word Review This garage door opener has been designed and tested
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 3
    the opener. • ONLY operate garage door opener at 120V, 60 Hz to avoid malfunction and damage. Tools needed During assembly, installation and adjustment of the opener, instructions will call for hand tools as illustrated below. Carpenter's Level (Optional) 12 Tape Measure Pencil Wire Cutters
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 4
    is needed for lightweight garage doors (fiberglass, steel, aluminum, door with glass panels, etc.). See page 18 for details. Header Wall FINISHED CEILING Support bracket & fastening hardware is required. See page 11. Slack in chain tension is normal when garage door is closed. Torsion Spring
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 5
    model purchased. is also listed below. LOCK LIGHT Smart Control Panel™ : SECURITY ® 3-Button Remote Control Model 373P (1) Remote Control Transmitter Visor Clip CEILING MOUNT ONLY UP Chassis Support Bracket Header Bracket Chain Motor Unit With Light Lenses Chain Spreader Door Bracket Rail
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 6
    the back flange and the hole in rail support (Figure 4). Proceed to Assembly Step 4. To avoid possible SERIOUS INJURY to fingers from moving garage door opener: • ALWAYS keep hand clear of sprocket while operating opener. • Securely attach chain spreader BEFORE operating. Figure 4 Hex Bolts
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 7
    connect garage door opener to power source until instructed to do so. 8. NEVER wear watches, rings or loose clothing while installing or servicing opener. They could be caught in garage door or opener mechanisms. 9. Install wall-mounted garage door control: • within sight of the garage door. • out
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 8
    bracket MUST be RIGIDLY fastened to structural support on header wall or ceiling, otherwise garage door might not reverse when required. DO (not provided) to securely fasten the 2x4 to structural supports as shown here and on page 9. 3. Open your door to the highest point of travel as shown. Draw an
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 9
    garage door, or to the ceiling. Follow the instructions which will work best Support Header Bracket CEILING MOUNT ONLY UP Vertical Centerline of Garage Door Lag Screws 5/16"-9x1-5/8" Door Spring Horizontal Line Highest Point of Garage Door Travel Garage Door Vertical Centerline of Garage Door
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 10
    Bracket Ring Fastener Clevis Pin 5/16"x2-3/4" Chain Pulley Bracket Rail Garage Door Temporary Support INSTALLATION STEP 4 Position the Opener SECTIONAL DOOR ONLY A 2x4 laid flat is convenient for setting an ideal door-to-rail distance. • Raise the opener onto a stepladder. You will need help at
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 11
    the top and underside of the rail surface where the trolley slides with rail grease. NOTE: DO NOT connect power to opener at this time. To avoid possible SERIOUS INJURY from a falling garage door opener, fasten it SECURELY to structural supports of the garage. Concrete anchors MUST be used if
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 12
    can be connected to each garage door opener. If additional wall controls are desired to operate the same garage door opener, it is recommended to use model 378LM wireless wall control as the secondary door control. 1. Strip 7/16" (11 mm) of insulation from one end of bell wire and connect to the two
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 13
    minutes when power is connected. Then the lights will turn OFF. • Reverse the procedure to close the lens. • Use A19, standard neck garage door opener bulbs for replacement. NOTE: Use only standard light bulbs. The use of short neck or speciality light bulbs may overheat the endpanel or light socket
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 14
    or DEATH from electrocution or fire: • Be sure power is not connected to the opener, and disconnect power to circuit BEFORE removing cover to establish permanent wiring connection. • Garage door installation and wiring MUST be in compliance with all local electrical and building codes. • NEVER use
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 15
    sensor must be connected and aligned correctly before the garage door opener will move in the down direction. IMPORTANT INFORMATION ABOUT unobstructed. No part of the garage door (or door tracks, springs, hinges, rollers or other hardware) may interrupt the beam while the door is closing.
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 16
    opener is disconnected. Install and align the brackets so the sensors will face each other across the garage door, with the beam no higher than 6" (15 cm) above the floor. They may be installed in one of three ways, as follows: Garage door If your door track will not support the bracket securely,
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 17
    Wing Nut 1/4"-20 Carriage Bolt 1/4"-20x1/2" Lens TROUBLESHOOTING THE SAFETY REVERSING SENSORS 1. If the sending eye indicator light does not glow steadily after installation, check for: • Electric power to the opener. • A short in the white or white/black wires. These can occur at staples, or at
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 18
    of angle iron are used to create a U-shaped support. The best solution is to check with your garage door manufacturer for an opener installation door reinforcement kit. NOTE: Many door reinforcement kits provide for direct attachment of the clevis pin and door arm. In this case you will not need the
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 19
    INSTALLATION STEP 12 Connect Door Arm to Trolley Inner Trolley SECTIONAL DOORS ONLY • Make sure garage door is fully closed. Pull the emergency release handle to disconnect the outer trolley from the inner trolley. Slide the outer trolley back (away from the door) about 2" (5 cm) as shown in
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 20
    by a closing garage door. • Incorrect adjustment of garage door travel limits will Troubleshooting, page 17. Test the door for binding: Pull the emergency release handle. Manually open and close the door. If the door is binding or unbalanced, call for a trained door systems technician. If the door
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 21
    settings regulate the amount of power required to open and close the door. If the forces are set too light, door travel may be interrupted by nuisance reversals in be SERIOUSLY INJURED or KILLED by a closing garage door. • Too much force on garage door will interfere with proper operation of safety
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 22
    the remote control push button to open the door. • Place the opener carton in the path of the door. • Press the remote control push button to close the door. The door will not move more than an inch (2.5 cm), and the opener lights will flash. The garage door opener will not close from a remote if
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 23
    systems technician. 14. ALWAYS disconnect electric power to garage door opener BEFORE making any repairs or removing covers. 15. SAVE THESE INSTRUCTIONS. Using Your Garage Door Opener Your Security✚® opener and hand-held remote control have been factory-set to a matching code which changes with
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 24
    (Automatic Light Feature): The opener light will turn on automatically when a person enters the garage. When a person walks in front of the door control, the feature Designed to prevent operation of the door from LOCK hand-held remote controls. However, the door will open and close from the Door
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 25
    opener lights flash, release all buttons. Test by pressing the remote push button. The opener lights should turn on or off but the door should not move. Troubleshooting PROBLEM or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 26
    correct? Review Installation Step 6, page 12. 3. The door operates from the Door Control, but not from the remote control: • Is the door push bar flashing? If your model has the Lock feature, make sure it is off. • Program the opener to match the remote control code. (Refer to instructions on the
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 27
    can be installed. This kit was designed to minimize vibration to the house and is easy to install. 6. The garage door opens and closes by itself: • Be sure that all remote control push buttons are off. • Remove the bell wire from the door control terminals and operate from the remote only. If this
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 28
    OWNER'S MANUAL. Message LEARN REMOTE CONTROL. PRESS LEARN BUTTON TO CONFIRM. Meaning: This message will appear if the Safety Reversing Sensors are out of alignment, if they are blocked or if the wiring is disconnected. To clear message from Door feature will disable the opener from receiving remote
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 29
    purchaser or supplier of the non-rolling code transmitter to circumvent that technical measure. Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will open and close when you press the large push button. Below are instructions
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 30
    garage door opener. door should move. To set a temporary PIN You may authorize access by visitors or service Opener can be closed by pressing only the ENTER button if the one button close feature has been activated. This feature has been activated at the factory. To activate or deactivate this feature
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 31
    m) Rail assembly 8' (2.4 m) Rail assembly 10' (3 m) Rail assembly 7' (2.1 m) Chain assembly 8' (2.4 m) Chain assembly 10' (3 m) Chain assembly Rail grease KEY PART NO. NO. DESCRIPTION 1 398LM Smart Control Panel™ 2 373P 3-button remote control 3 10A19 3V2016 lithium battery: Led and opener
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 32
    Drive Gear Center Limit Contact (Up) Contact Grey Wire Yellow Wire KEY NO. 1 2 3 4 5 6 7 8 9A 9B 9C 10 11 12 PART NO. 41C5069 41A4208-2 41A5658 41A2817 41B4245-1 41A5484 4A1344 108D79 30B530 30B529 41A5637 41A3150 81C253 41A5640 DESCRIPTION Chassis support bracket assy. kit Chain spreader Gear
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 33
    their garage door opener remote or from anywhere in their home with an additional LiftMaster Security✚® remote. Laser Park Assist: Laser enables homeowners to precisely park vehicles in the garage. Surge Protector: The Garage Door Opener Surge Protector is designed to protect LiftMaster® garage door
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 34
    NOTES 34
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 35
    NOTES 35
  • LiftMaster 3595 | 3595 Elite Series Manual - Page 36
    • PART NUMBER • PART NAME • MODEL NUMBER ADDRESS ORDERS TO: THE CHAMBERLAIN GROUP, INC. Technical Support Group 6020 S. Country Club Road Tucson, Arizona 85706 SERVICE INFORMATION TOLL FREE NUMBER: 1-800-528-9131 LIFTMASTER® FIVE-YEAR LIMITED WARRANTY LIFETIME MOTOR LIMITED WARRANTY The Chamberlain
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
GARAGE DOOR OPENER
Model 3595 3/4 HP
For Residential Use
Install on Sectional Doors ONLY
THIS OPERATOR IS INTENDED FOR USE ONLY WITH I-BEAM RAILS.
Owner’s Manual
■
Please read this manual and the enclosed safety materials carefully!
■
Fasten the manual near the garage door after installation.
■
The door WILL NOT CLOSE unless the Protector System
®
is connected and properly
aligned.
■
Periodic checks of the opener are required to ensure safe operation.
■
The model number label is located under the light lens on the left side panel of your
opener.
The Chamberlain Group, Inc.
845 Larch Avenue
Elmhurst, Illinois 60126-1196
www.liftmaster.com
®