LiftMaster GH GT- Logic 4 Installation Manual - Page 16
Typical Installation, Assembly - door spring adjustment
View all LiftMaster GH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
ASSWEMARBLNYING WARNING CAUTION ASSEMBLE THE OPERATOR It is imperative that the wall or mounting surface provide adequate support for the operator. This surface must: a. Be rigid to prevent play between the operator and the door shaft. b. Provide a level base. c. Permit the operator to be fastened securely and with the drive shaft parallel to the door shaft. 1 Select handing. Right (R) or Left (L). On models J, H, HJ and GH operators the drive sprocket can be mounted on either the right or left side. AVERTISSEMENT For models H and HJ with manual hand chain systems, the handing of the operator must be determined at the time of order. The handing is indicated by the last letter of the model number (R or L). The hand chain wheel cannot be switched. If your ATTENTION installation causes the hand chain to hang in the door opening, hook the chain to the side near the top of the door jamb. WARNING To prevent possible SERIOUS INJURY or DEATH: • DO NOT connect electric power until instructed to do so. • If the door lock needs to remain functional, install an interlock switch. • ALWAYS call a trained door systems technician if door binds, sticks or is out of balance. An unbalanced door may NOT reverse when required. • NEVER try to loosen, move or adjust doors, door springs, cable, pulleys, brackets or their hardware, ALL of which are under EXTREME tension and can cause SERIOUS PERSONAL INJURY. • Disable ALL locks and remove ALL ropes connected to door AVERTISSEMENT BEFORE installing and operating door operator to avoid entanglement. • Fasten the operator SECURELY to structural supports of the AVERTISSEMENT building. • Concrete anchors MUST be used if installing ANY brackets. EXAMPLE: Right Hand HOIST AND JACKSHAFT TYPICAL INSTALLATION DEATDERVMEINRETMEOUNNCTIIANG LOCATION 1 The operator may be mounted on the wall, shelf or bracket (not provided, see accessories). The optimum distance between PRECAUCIÓN the door shaft and operator drive shaft is 12 - 15 inches. 1a Wall mount 1b Shelf or bracket mount 1a 1b ADVERTENCIA ADVERTENCIA 12" - 15" Assembly/Typical installation - Hoist and Jackshaft 16 12" - 15"