LiftMaster LA400 LA400 Pull to Open Addendum Manual
LiftMaster LA400 Manual
 |
UPC - 753182403953
View all LiftMaster LA400 manuals
Add to My Manuals
Save this manual to your list of manuals |
LiftMaster LA400 manual content summary:
- LiftMaster LA400 | LA400 Pull to Open Addendum Manual - Page 1
used to mount operator if needed Addendum to LA400 Owner's Manual Acceptable Configurations (will vary based on site conditions) DETERMINE MOUNTING LOCATION The gate post bracket assembly can be mounted several places on the gate post. Ideally, the distance between and opener hinge points should - LiftMaster LA400 | LA400 Pull to Open Addendum Manual - Page 2
. Attach operator arm to brackets with pins and clips provided (Figure 2). Figure 2 Operator must be level C-Clamp Actuator Side Pin Gate Bracket Hairpin Clip C-Clamp Disengage the operator by inserting the key and rotating the handle (Figure 3). Move the gate manually to the fully open and
-
1 -
2
 |
 |
Typical 4" Post Hole
Acceptable Configurations (will vary based on site conditions)
Typical 6" Post Hole
Can also be used to mount operator if needed
The addition of this hole helps
add up to 30-degrees of movement in
some applications.
Gate Post
Opener Hinge Point
Gate Hinge Point
Gate Hinge Point
Gate Hinge Point
Gate Hinge Point
Gate Hinge Point
Gate Hinge Point
7"
7"
Opener Hinge Point
Opener Hinge Point
Gate Post
Gate Post
Gate Post
Gate Post
Gate Post
7"
7"
Opener
Hinge Point
7"
7"
Opener
Hinge Point
7"
7"
Opener
Hinge Point
7"
7"
7"
7"
Addendum to LA400
Owner’s Manual
LA400 BRACKET CONFIGURATIONS
Assemble bracket.
NOTE:
This new bracket is being added to the LA400, offering
greater mounting flexibility.
DETERMINE MOUNTING LOCATION
The gate post bracket assembly can be mounted several places
on the gate post.
Ideally, the distance between and opener hinge points should be
approximately 7" x 7". Place
opener against gate post and adjust
the opener until the required dimension is achieved (Figure 1).
Figure 1