Lowrance HOOK-3x Operators Manual EN

Lowrance HOOK-3x Manual

Get Lowrance HOOK-3x PDF manuals and user guides View all Lowrance HOOK-3x manuals
Add to My Manuals
Save this manual to your list of manuals

Lowrance HOOK-3x manual content summary:

  • Lowrance HOOK-3x | Operators Manual EN - Page 1
    HOOK-X Series Operation manual ENGLISH HOOK-4x HOOK-5x HOOK-7x lowrance.com
  • Lowrance HOOK-3x | Operators Manual EN - Page 2
    any time. We reserve the right to do so without notice. All features and specifications subject to change without notice. Compliance Statements Lowrance HOOK-4x, HOOK-5x and HOOK-7x • meets the technical standards in accordance with Part 15.103 of the FCC rules • complies with CE under EMC directive
  • Lowrance HOOK-3x | Operators Manual EN - Page 3
    and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, the dealer or an experienced technician for help NOTE: This manual covers HOOK-4x, HOOK-5x and HOOK-7x units. As a result, screenshots of menus and dialogs may not
  • Lowrance HOOK-3x | Operators Manual EN - Page 4
    Cursor 11 Advanced mode 11 Restore defaults 11 Pages 12 Sonar page 12 DownScan page 12 Combo pages 13 Overlay data 14 Sonar operation 15 CHIRP 15 Trackback 16 Sonar menu 16 Sensitivity 17 Table of contents
  • Lowrance HOOK-3x | Operators Manual EN - Page 5
    25 Ping Speed 27 DownScan options 27 Settings 30 Settings menu 30 System 30 Set language 31 Audio 31 Alarms 31 Units 32 NMEA 0183 (HOOK-5x and HOOK-7x only 32 Specifications 33 5 Table of contents
  • Lowrance HOOK-3x | Operators Manual EN - Page 6
    Press the LIGHT/POWER key to backlight switch backlight levels. Muting Audio Select Audio from the System menu and press ENTER. Enable/ disable Mute. Introduction | HOOK X series 6
  • Lowrance HOOK-3x | Operators Manual EN - Page 7
    be accessed when those pages are displayed. Pages Pages dialog DownScan page DownScan menu NOTE: Available pages vary depending on the unit and the connected transducer. 7 Basic operation | HOOK X series
  • Lowrance HOOK-3x | Operators Manual EN - Page 8
    page menu for active page will be displayed when the MENU key is pressed. The active panel is denoted by an orange border. Basic operation | HOOK X series 8
  • Lowrance HOOK-3x | Operators Manual EN - Page 9
    or close the dialog. Dropdown menus Access the dropdown menu and press use the keypad to select the desired item and press ENTER. 9 Basic operation | HOOK X series
  • Lowrance HOOK-3x | Operators Manual EN - Page 10
    fishing NOTE: Use Fresh Water mode when fishing in less than 100 feet of water; otherwise your unit may not track bottom properly. Basic operation | HOOK X series 10
  • Lowrance HOOK-3x | Operators Manual EN - Page 11
    display, allowing you to scroll the map, select map items and review sonar history. Press MENU and select Return to vessel or Exit Units (Enables distance, speed, depth, temperature, and bearings options) • HOOK-5x & HOOK-7x only: NMEA 0183 Output (Requires optional Power/NMEA cable 000-0127-49)
  • Lowrance HOOK-3x | Operators Manual EN - Page 12
    moving from right to left. You can overlay downscan sonar on the conventional sonar page by selecting DownScan Overlay on the Sonar settings menu. Pages | HOOK X series 12
  • Lowrance HOOK-3x | Operators Manual EN - Page 13
    page from the Pages carousel and press MENU. NOTE: To adjust panel size, access the customize menu after selecting a combo page for display. 13 Pages | HOOK X series
  • Lowrance HOOK-3x | Operators Manual EN - Page 14
    . 6. Select the desired data and press ENTER. 7. Press MENU and select Return to Overlays. Press ENTER. 8. Press MENU, select Done configuring and press ENTER. Pages | HOOK X series 14
  • Lowrance HOOK-3x | Operators Manual EN - Page 15
    penetration. This unit supports High CHIRP, Medium CHIRP and Low CHIRP, depending on the transducer. CHIRP can be used with Lowrance conventional sonar transducers. • 50/200 kHz (Low/High CHIRP) • 83/200 kHz (Medium/High CHIRP) To use CHIRP, select the desired CHIRP frequency from the Frequency
  • Lowrance HOOK-3x | Operators Manual EN - Page 16
    Trackback You can review your recent sonar history by moving the cursor to the left until the screen starts to move in reverse. Blue mode) (Only active with Downscan overlay turned on) Adjust Used to make adjustments to Sensitivity and Colorline/Grayscale. Sonar operation | HOOK X series 16
  • Lowrance HOOK-3x | Operators Manual EN - Page 17
    water column that does not include the water surface or the bottom. Upper and lower limits must be at least 6.5 ft (2 m) apart. 17 Sonar operation | HOOK X series
  • Lowrance HOOK-3x | Operators Manual EN - Page 18
    , or you may receive incorrect depth information. Frequency Controls the transducer frequency used by the unit. This unit supports conventional, CHIRP and DownScan sonar frequencies. Only frequencies supported by your transducer will appear on the Frequency menu. 50 kHz Sonar frequencies Best
  • Lowrance HOOK-3x | Operators Manual EN - Page 19
    send sonar waves into the water. Ping speed adjustments can help reduce interference from other transducers. When using fishing modes, ping speed settings are optimized for the selected fishing conditions, on your display, and then filters out undesired signals. 19 Sonar operation | HOOK X series
  • Lowrance HOOK-3x | Operators Manual EN - Page 20
    can make adjustments to DownScan overlay settings from the sonar page. DownScan options are covered in more detail in the DownScan operation section. Sonar operation | HOOK X series 20
  • Lowrance HOOK-3x | Operators Manual EN - Page 21
    the Pages section. Overlay data NOTE: The DownScan options menu will only be available when DownScan overlay is enabled. Stop sonar Prevents the transducer from transmitting to reduce/eliminate interference between two sonar units running on the boat at the same time. NOTE: Sonar history will not
  • Lowrance HOOK-3x | Operators Manual EN - Page 22
    adjustments made to conventional sonar settings will be visible on the sonar page. Manual mode Restricts digital depth capability, so the unit will only send sonar signals bottom depth is out of transducer range. WARNING: Manual mode should only be used by advanced sonar users. Sonar operation
  • Lowrance HOOK-3x | Operators Manual EN - Page 23
    in manual mode, mode. Installation Installation menu Keel offset All transducers measure water depth from the transducer to the bottom. As a result, transducer to the keel/bottom of motor or from the transducer to the water surface. Before setting keel offset, measure the distance from the transducer
  • Lowrance HOOK-3x | Operators Manual EN - Page 24
    as (minus) -1 foot. Water speed calibration Calibrates a paddlewheel speed sensor. Transducer type Selects the type of transducer model attached to your unit. Temperature calibration Calibrates data from the transducer temperature sensor with data from a known temperature source to ensure the
  • Lowrance HOOK-3x | Operators Manual EN - Page 25
    sonar. DownScan menu Press MENU from the DownScan page to view the DownScan menu. Trackback You can review your sonar history by pressing the keypad to the left until the screen starts to move in reverse scrolling, or press MENU and select Exit cursor mode. 25 DownScan operation | HOOK X series
  • Lowrance HOOK-3x | Operators Manual EN - Page 26
    column. That allows you to view a section of the water column. Contrast set to 40 Contrast set to 60 Contrast set to 80 DownScan operation | HOOK X series Upper and lower limits must be at least 6.5 ft (2 m) apart. 26
  • Lowrance HOOK-3x | Operators Manual EN - Page 27
    you may receive incorrect depth information. DownScan options Frequency Controls the transducer frequency used by the unit. 800 kHz offers the best . Ping speed adjustments can help reduce interference from other transducers. Noise Rejection Uses advanced signal processing to monitor the effects
  • Lowrance HOOK-3x | Operators Manual EN - Page 28
    is useful for viewing structure detail and determining bottom hardness. Sepia is best for looking at bottom detail. Stop sonar Prevents the transducer from transmitting to reduce/eliminate interference between two sonar units running on the boat at the same time. NOTE: Sonar history (Trackback
  • Lowrance HOOK-3x | Operators Manual EN - Page 29
    Overlay data Allows you to select data to be displayed on top of the DownScan page. Overlay data setup is covered in the Pages section. Overlay data Settings Accesses the Settings menu. Refer to "Sonar settings" on page 22. 29 DownScan operation | HOOK X series
  • Lowrance HOOK-3x | Operators Manual EN - Page 30
    and configuration settings for your unit. System Adjusts unit settings like language, mute audio and advanced mode. (Advanced mode only, HOOK-5x & HOOK-7x) Settings menu (Advanced mode only) System menu Enables advanced features. Refer to "Advanced mode" on page 11. Displays software
  • Lowrance HOOK-3x | Operators Manual EN - Page 31
    mode. check the version of software your unit is using by accessing the About screen. Lowrance periodically updates unit software to add features and improve functionality. To see the latest available software unit. Before attempting a software update, you can 31 Alarms menu Settings | HOOK X series
  • Lowrance HOOK-3x | Operators Manual EN - Page 32
    vessel enters water shallower than the selected shallow threshold Sounds alarm when a fish symbol (Fish ID) appears on the sonar screen NMEA 0183 (HOOK-5x and HOOK-7x only) (optional Power/NMEA cable 000-0127-49) You can select the NMEA 0183 sentences the unit will use when connected a NMEA 0183
  • Lowrance HOOK-3x | Operators Manual EN - Page 33
    ft (762 m) 50/200 kHz Available transducer frequencies 455/800 kHz 50/83/200 kHz High/Medium/Low CHIRP Max speed 70 mph Transducer HDI 50/200 kHz (Low/High CHIRP) HDI 83/200 kHz (Medium/High CHIRP) 83/200 kHz (Medium/High CHIRP) Transducer cable 20 ft (6 m) 33 Specifications | HOOK X series
  • Lowrance HOOK-3x | Operators Manual EN - Page 34
    Transducer Transducer cable Sonar 300 ft (91 m) 455/800 kHz 1000 ft (305 m) 83/200 kHz 2500 ft (762 m) 50 kHz 455/800 kHz 50/83/200 kHz High/Medium/Low CHIRP 70 mph HDI 50/200 kHz (Low/High CHIRP) HDI 83/200 kHz (Medium/High CHIRP) 83/200 kHz (Medium/High CHIRP) 20 ft (6 m) Specifications | HOOK
  • Lowrance HOOK-3x | Operators Manual EN - Page 35
    Contact information Customer Service: AMER: 800-628-4487 EMEA: +44 1794 51 0010 APAC: 1300 628426 Ordering accessories US: http://store.navico.com Other countries: Visit your local dealer or distributor. Visit our website For additional regional support information: www.lowrance.com/technicalsupport
  • Lowrance HOOK-3x | Operators Manual EN - Page 36
    *988-11012-002* www.lowrance.com
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
lowrance.com
ENGLISH
HOOK-X Series
Operation manual
HOOK-4x
HOOK-5x
HOOK-7x