Mackie FRS1300/1700/2800 Owner's Manual

Mackie FRS1300/1700/2800 Manual

Get Mackie FRS1300/1700/2800 PDF manuals and user guides View all Mackie FRS1300/1700/2800 manuals
Add to My Manuals
Save this manual to your list of manuals

Mackie FRS1300/1700/2800 manual content summary:

  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 1
    TWO CHANNEL POWER AMPLIFIERS FRS•1300, FRS•1700, and FRS•2800 OWNER'S MANUAL FRS•2800 FAST RECOVERY POWER AMPLIFIER 1 OL -3 -6 -9 -20 MAX SIG 2 OL -3 -6 -9 -20 SIG MAX OO OO FAST RECOVERY POWER AMPLIFIER CHANNEL 2 BRIDGED CHANNEL 1 : WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 2
    FRS SERIES AMPLIFIERS Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions the power cord SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED PERSONNEL ATTENTION: POUR EVITER LES RISQUES DE CHOC ELECTRIQUE, NE PAS
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 3
    16 BLOCK DIAGRAM 17 DIMENSIONS 18 LIMITED WARRANTY 19 Need help with your new FRS amplifier? • Visit www.mackie.com and click Support to find: FAQs, manuals, addendums, and user forums. • Email us at: [email protected]. • Telephone 1-800-898-3211 to speak with one of our splendid technical
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 4
    Mackie power amplifier. Please read these instructions to get the maximum performance from your amplifier, and to make the technical writer feel loved. The FRS series amplifiers of level controls HOW TO USE THIS MANUAL After this introduction, a getting started guide will help you get things set up
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 5
    , and get the levels just right. Settings: 1. Be sure the amplifier's power switch is off. 2. Turn down both level controls. 3. On the rear panel, set the subsonic filter switch off and the clip limit switch on. 4. Determine which amp mode is best for your application: Stereo mode is the typical
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 6
    2+ 2 1+ 1 CH 1 ??? Confused cat Passive loudspeakers Mackie S215 Passive loudspeakers Mackie S215 FILTER SUBSONIC @ 30Hz CLIP LIMIT AMP MODE AMP MODE SWITCH MONO CH 1 AND CH 2 PLAY THE SAME Bridged mono FRS•2800 FAST RECOVERY POWER AMPLIFIER 1 OL -3 -6 -9 -20 MAX SIG 2 OL -3 -6 -9 -20
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 7
    MODE AMP MODE SWITCH STEREO OPTIONAL CONNECTION USING BINDING POSTS + TO + SPEAKERS FAST RECOVERY POWER AMPLIFIER CHANNEL 2 BRIDGED CHANNEL 1 : WARNING TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. DO NOT REMOVE COVER. NO USER SERVICEABLE PARTS
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 8
    after the level controls, at the output stage of the power amplifier. If the level controls are turned all the way down (fully counterclockwise), these indicators will not light. 434 2 1 FRS•2800 FAST RECOVERY POWER AMPLIFIER 1 OL -3 -6 -9 -20 MAX SIG 2 OL -3 -6 -9 -20 SIG MAX OO OO
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 9
    Owner's Manual Rear Panel Features 5. POWER CORD SOCKET This is where you connect the detachable power cord included with your amplifier. Plug the other end of the power cord into an AC outlet properly configured with the voltage required for your particular model. Be sure the AC outlet can supply
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 10
    IN CHINA FABRIQUE EN CHINE • COPYRIGHT ©2007 "MACKIE", AND THE RUNNING MAN FIGURE ARE TRADEMARKS OF LOUD TECHNOLOGIES, INC. SPEAKER OUTPUTS PIN PIN PIN 1+ 1 BRIDGED 1+ 2+ 1+ 1 PIN CH 2 2+ 2 1+ 1 CH 1 10 FRS SERIES AMPLIFIERS FILTER SUBSONIC @ 30Hz CLIP LIMIT AMP MODE 10 11 12
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 11
    amplifiers require the following average currents: FRS•1300 = 6 A FRS•1700 = 8 A FRS•2800 =11 A It is recommended that a stiff supply of AC power be used because the amplifier amplifier, you must secure the rear support brackets of the amplifier to the back of the rack. You could use a support rail
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 12
    FRS SERIES AMPLIFIERS Appendix A: Service Information If you think your Mackie product has a problem, please check out the following troubleshooting tips and do your best to confirm the problem. Visit the Support section of our website (www.mackie.com/support • The power amplifier is clipping.
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 13
    a Service Center." Service for Mackie products living outside the United States can be obtained through local dealers or distributors. If you do not have access to our website, you can call our Tech Support department at 1-800-898-3211, MondayFriday, 7 am to 5 pm Pacific Time, to explain the problem
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 14
    FRS SERIES AMPLIFIERS Appendix B: Connections, math and stuff Use a high-quality 3-conductor shielded cable to connect the signal between the signal source (mixing console, equalizer, etc.) and the balanced inputs to the amplifier size will result in higher power losses. Minimum AWG 18 16
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 15
    section of the missing manual. If you're amp's negative output. Series connections are not normally used in PA applications because it ruins the amplifier amp: • The lower the speaker impedance, the more power can be put out by the amplifier. • Driving lower impedance speakers makes the amplifier
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 16
    FRS SERIES AMPLIFIERS Appendix C: Technical Info Specifications Continuous Sine Wave Average Output Power, per channel, both channels driven, 20 Hz to 20 kHz FRS•1300 FRS•1700 FRS•2800 these specifications at any time without notice. "Mackie," and the "Running Man" are registered trademarks
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 17
    17 Owner's Manual INPUT 1 BALANCED LINE INPUT (XLR-F) INPUT 1 BALANCED LINE INPUT (TRS) INPUT 2 BALANCED LINE INPUT (XLR-F) INPUT 2 BALANCED LINE INPUT (TRS) POWER SWITCH FRS SERIES BLOCK DIAGRAM 04.06.07 ON OFF SUBSONIC FILTER ON OFF CHANNEL 1 LEVEL AMP MODE SWITCH CHANNEL 2 MONO LEVEL
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 18
    09 in/ 434 mm 1.50 in/ 38 mm 3.50 in/ 88.9 mm OO FRS•2800 FAST RECOVERY POWER AMPLIFIER 1 OL -3 -6 -9 -20 MAX SIG 2 OL -3 -6 -9 -20 SIG MAX OO 19.0 in/ 483 mm FRS•1300 WEIGHT 21 lbs. (9.5 kg) FRS•1700 WEIGHT 21.5 lbs. (9.7 kg) FRS•2800 WEIGHT 22 lbs. (10 kg) 1.50 in/ 38 mm 14.65 in
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 19
    Have your Mackie product's serial number ready. You must have a Service Request Number before you can obtain factory-authorized service. • Pack the product in its original shipping carton. Also include a note explaining exactly how to duplicate the problem, a copy of the sales receipt with price and
  • Mackie FRS1300/1700/2800 | Owner's Manual - Page 20
    16220 Wood-Red Road NE • Woodinville, WA 98072 • USA United States and Canada: 800.898.3211 Europe, Asia, Central and South America: 425.487.4333 Middle East and Africa: 31.20.654.4000 Fax: 425.487.4337 • www.mackie.com E-mail: [email protected]
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
OWNER’S MANUAL
TWO CHANNEL POWER AMPLIFIERS
FRS•1300, FRS•1700, and FRS•2800
FRS Series
OL
-3
-6
-9
-20
SIG
OL
-3
-6
-9
-20
SIG
2
O
O
MAX
MAX
O
O
1
FRS
•
2800
FAST RECOVERY POWER AMPLIFIER
AMP MODE
DESIGNED BY MACKOIDS IN WOODINVILLE, WA, USA • MANUFACTURED IN CHINA FABRIQUE EN CHINE • COPYRIGHT ©2007
"MACKIE", AND THE RUNNING MAN FIGURE ARE TRADEMARKS OF LOUD TECHNOLOGIES, INC.
CHANNEL 2
CHANNEL 1
BRIDGED
BRIDGED
CH 1
CH 2
CLIP LIMIT
FILTER
SUBSONIC @ 30Hz
SPEAKER OUTPUTS
PIN
1+
1
PIN
1+
2+
PIN
2+
2
PIN
1+
1
FAST RECOVERY
POWER AMPLIFIER
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES FOR
THE U.S. AND ICES-003, FOR CANADA.
OPERATION IS SUBJECT
TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY
NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE
MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING
INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
WARNING
:
TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR
MOISTURE. DO NOT REMOVE COVER. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
AVIS
:
RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR