Magnavox TB110MW9 User manual, English (US) - Page 7

Information on Digital Broadcasting, Accessories, Installing BatteriesIns, CAUTION - digital to analog converter

Page 7 highlights

Before Using Information on Digital Broadcasting Receives ATSC ATSC Digital terrestrial antenna STB (Set Top Box) converts the ATSC signal to analog signal TV Digital terrestrial signals This STB makes it possible to view the digital TV programs on your analog TV by converting the digital signal to the analog signal. You can use most features provided by the digital broadcast, except that the resolution of the image is always output in 480i (standard resolution). Accessories Check the following accessories when unpacking the STB: Remote control: NA386UD (x1) Owner's manual: 1VMN25977 (x1) AA battery (1.5V) x 2 RF cable: WPZ0901TM002 / WPZ0901TM005 (x1) Installing Batteries Instalación de pilas 1 Unsnap the battery cover from the back of the remote control. Abra la cubierta de pilas de la parte trasera del mando a distancia. 2 Install two AA batteries making sure the polarity (+ / - ) is correct. Instale dos pilas AA asegurándose que la polaridad (+ / - ) sea la correcta. 3 Snap the battery cover back. Cierre la cubierta de pilas. NOTE: • When replacing batteries, replace them in pairs. Cuando cambie las pilas, hágalo por pares. CAUTION: • Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries. No mezcle baterías alcalinas, estándar (zinc-carbono) o recargables (ni-cad, ni-mh, etc.). • Do not mix new and old batteries together. No mezcle pilas nuevas con antiguas. • Do not recharge, short-circuit, heat, burn or disassemble batteries. No recargue, caliente, queme o desarme baterías ni provoque un corto circuito con ellas. • Remove batteries from battery compartment that is not going to be used for a month or more. Quite las pilas del compartimento de pilas si no se va a utilizar durante un mes o más. 7 EN

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32

7
EN
Before Using
Information on Digital Broadcasting
Digital terrestrial
antenna
Digital
terrestrial signals
STB (Set Top Box)
converts the ATSC signal
to analog signal
TV
Receives
ATSC
ATSC
This STB makes it possible to view the digital TV
programs on your analog TV by converting the
digital signal to the analog signal. You can use
most features provided by the digital broadcast,
except that the resolution of the image is always
output in 480i (standard resolution).
Accessories
Check the following accessories when unpacking the STB:
Remote control:
NA386UD (x1)
Owner’s manual:
1VMN25977 (x1)
AA battery (1.5V) x 2
RF cable:
WPZ0901TM002 /
WPZ0901TM005 (x1)
Installing Batteries
Instalación de pilas
1
Unsnap the battery cover from the
back of the remote control.
Abra la cubierta de pilas de la parte
trasera del mando a distancia.
2
Install two AA batteries making
sure the polarity (+ /
-
) is correct.
Instale dos pilas AA asegurándose que
la polaridad (+ /
-
) sea la correcta.
3
S
Snap the battery
c
cover back.
Cierre la cubierta de
pilas.
CAUTION:
Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad,
ni-mh, etc) batteries.
No mezcle baterías alcalinas, estándar (zinc-carbono) o recargables (ni-cad, ni-mh, etc.).
Do not mix new and old batteries together.
No mezcle pilas nuevas con antiguas.
Do not recharge, short-circuit, heat, burn or disassemble batteries.
No recargue, caliente, queme o desarme baterías ni provoque un corto circuito
con ellas.
Remove batteries from battery compartment that is not going to be
used for a month or more.
Quite las pilas del compartimento de pilas si no se va a utilizar durante un mes o más.
NOTE:
When replacing batteries,
replace them in pairs.
Cuando cambie las pilas,
hágalo por pares.