Magnavox TB600MG2F User manual, English (US) - Page 18
Manual Wired
View all Magnavox TB600MG2F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Manual (Wired) In the following cases, select "Manual"(wired) to set each setting as necessary. - If a network connection could not be established when the setting was "Auto"(wired). - When instructed by your Internet service provider to make specific settings in accordance with your network environment. 1. Use [Í / Æ] to select "Network Setup" in the home menu, then press [OK]. 2. At "IP Mode", press [OK] , and set it to "Manual", then press [OK]. Wired IP Settings Link Status :Link Up MAC Address :XX:XX:XX:XX:XX IP Mode :Manual Please choose a new IP Mode value IP Address :XX:XX:XX:XX:XX Manual Subnet Mask :XX:.XX:X.X:XX.:XX DefaAuluttGoateway :XX:XX:XX:XX:XX Primary DNS :XX:XX:XX:XX:XX Secondary DNS :XX:XX:XX:XX:XX Apply Cancel Network Test 3. Use [Î / ï] to select "IP Address", then press [OK]. 4. The IP address setting screen will appear. Enter an IP address using on the software keyboard, then select "Done", then press [OK]. Wired IP Settings Link Status :Link Up MAC Address :XX:XX:XX:XX:XX IP MoPdleease enter a:MnaenwuaIPl Address. Valid range of each segment is 0 to 225. IP Address :XX:XX:XX:XX:XX Current Value xxx.xxx.x.xxx SuNbenwetVMalausek :XX:X. X:XX. :XX:X.X DeDfaounlet G1at2ew3ay 4:X5X:X6X:7XX8:XX9 :X0X Primary qDNwS e r :XX:yXXu:XX:XoXp:XX asd f gh j k l ; Secondarzy DxNcS v :XbX:nXXm:XX, :X. X:/XX Apply Space C` an-cel= \ N[ et]wor'k Test • The software keyboard shows up by pressing [OK] on the remote while in a number cell. • When inputting a single character using the software keyboard as soon as you press [OK] on the remote to input that character, then the character is displayed for a very short time to allow you to confirm that this was the correct character. • Enter an IP address after checking the specifications of your router. • If an IP address is unknown, check the IP address of other devices (e.g. PC connected with a LAN cable). Then, in the furthest cell to the right, assign a different number from those other devices. 5. Use [Î / ï] to select "OK", then press [OK]. 6. Repeat the same procedure as steps 4 to 5 for "Subnet Mask", "Default Gateway", "Primary DNS" and "Secondary DNS". • Enter the DNS addresses provided by your Internet provider. • If the DNS address is unknown, check the DNS address of other devices (e.g. PC connected with a LAN cable) and assign the same DNS address. 7. Use to select "Apply", then press [OK]. • The unit will start a network test, and the test result will appear right after the test finishes. 8. If the network test passes, press [OK] to exit. EN-18 Continued on next page.