Magnavox TB600MG2F User manual, English (US) - Page 7

Installing the Batteries in the Remote Control, Using the Remote Control

Get Magnavox TB600MG2F PDF manuals and user guides View all Magnavox TB600MG2F manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

■ Installing the Batteries in the Remote Control Install 2 AAA (1.5V) batteries matching the polarity indicated inside the battery compartment of the remote control. EN C Caution Incorrect use of batteries can result in hazards, such as leakage and bursting. Please observe the following: • Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries. • Do not mix new and old batteries together. • Do not use different kinds of batteries together. Although they may look similar, different batteries may have different voltages. • Make sure that the + and - ends of each battery match the indications in the battery compartment. • Remove batteries from the battery compartment when the remote is not going to be used for a month or more. • When disposing of used batteries, please comply with governmental regulations or environmental public rules that apply in your country or area. • Do not recharge non-rechargeable batteries. • Do not short-circuit, heat or burn any batteries. ■ Using the Remote Control Remote Control Usage Guidelines: • To check remote operation, aim the remote at the unit then press any arrow button. The Standby/on Indicator on the unit will turn Off when the button is pressed and turn On again when the button is released. This confirms that the unit is receiving the IR remote signal. • Make sure that there are no obstacles between the remote control and the infrared sensor window on the unit. • Do not mount the device on the wall behind the TV as this would block the infrared sensor window from the remote infrared signal. • Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the infrared sensor window of the unit. • Remote controls of different devices can interfere with each other. Avoid using a remote control of another device which is located close to the unit. • Replace the batteries when you notice a fall-off in the operating range of the remote control. • The maximum operable ranges from the unit are as follows. Line of sight : approx. 23 feet (7 m) Either side : approx. 16 feet (5 m) within 30° of the center Above : approx. 16 feet (5 m) within 15° Below : approx. 10 feet (3 m) within 30° 30˚ 30˚ 30˚ 30˚ EN-7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
EN
EN-7
■
Installing the Batteries in the Remote Control
Install 2 AAA (1.5V) batteries matching the polarity indicated inside the battery compartment of the remote control.
C
Caution
Incorrect use of batteries can result in hazards, such as leakage and bursting.
Please observe the following:
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc) batteries.
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together.
Although they may look similar, different batteries may have
different voltages.
• Make sure that the + and - ends of each battery match the indications in the battery compartment.
• Remove batteries from the battery compartment when the remote is not going to be used for a month or more.
• When disposing of used batteries, please comply with governmental regulations or environmental public rules
that apply in your country or area.
• Do not recharge non-rechargeable batteries.
• Do not short-circuit, heat or burn any batteries.
■
Using the Remote Control
Remote Control Usage Guidelines:
• To check remote operation, aim the remote at the unit then press any arrow button.
The Standby/on Indicator
on the unit will turn Off when the button is pressed and turn On again when the button is released.
This
confirms that the unit is receiving the IR remote signal.
• Make sure that there are no obstacles between the remote control and the infrared sensor window on the unit.
• Do not mount the device on the wall behind the TV as this would block the infrared sensor window from the
remote infrared signal.
• Remote operation may become unreliable if strong sunlight or fluorescent light is shining on the infrared sensor
window of the unit.
• Remote controls of different devices can interfere with each other.
Avoid using a remote control of another
device which is located close to the unit.
• Replace the batteries when you notice a fall-off in the operating range of the remote control.
• The maximum operable ranges from the unit are as follows.
30˚
30˚
30˚
30˚
Line of sight
: approx.
23 feet (7 m)
Either side
of the center
: approx.
16 feet (5 m) within 30°
Above
: approx.
16 feet (5 m) within 15°
Below
: approx.
10 feet (3 m) within 30°