Marantz AV7005 AV7005 User Manual - English - Page 97

Simple version Basic version SVENSKA NEDERLANDS ESPAÑOL ITALIANO FRANÇAIS DEUTSCH ENGLISH Operating components nnSet top box for satellite (SAT) operation Operation buttons SOURCE ON/OFF CHANNEL +, - uio p ENTER 0 - 9 CLR TV POWER TV INPUT Function Power on/standby Switch channels (up/down) Cursor operation Enter Channel selection Clear the inputting TV power on/standby (Default : Marantz) Switch TV input (Default : Marantz) Operating learn function • If the AV device is not a Marantz device, or if the device does not operate even when the preset code is registered, use the learning function. Remote codes for different devices can be remembered for use by the Marantz remote control included with this device. • This remote control unit is capable of learning around 160 codes. Remembering remote control codes from other devices 1 Place the Marantz remote control and remote control from the other device approximately 5 cm apart, with the remote control signal transmission sections facing each other. 5 Press and hold the button that you want to register on the other remote control until "OK" is displayed on the Marantz remote control display. • If "NG" is shown on the remote control display, perform step 5 again. If "NG" is shown again on the remote control display, the remote control may not be able to learn the code correctly. In this case, use the specialized remote control for the device. • If the remote control memory becomes full, "FULL" is shown on the remote control display. If you want to learn the code, you should erase other learned button. 6 Repeat steps 4 and 5 to learn other buttons for the same input source. 7 Repeat steps 3 to 6 to learn other input sources. 5 cm 8 When programming of the remote control unit is completed, press SET. The LEARN display disappears, and the remote control unit exits learn mode. 2 Press and hold down SET and SOURCE SEL until the LEARN indicator blinks. 3 Press input source select buttons to select the input source. The input source is shown in the remote control display. 4 Select the button to be learned. LEARN indicator lights up. NOTE • The learning function is unavailable for all SOURCE ON/OFF, MACRO and HDMI in any mode. • The learning function is unavailable for all buttons in TUNER mode, AMP mode, NET/USB mode and M-XP mode. • The learning procedure does not operate correctly if the batteries have become worn. • If no buttons are pressed for approximately 1 minutes while in the LEARN mode, the remote control unit automatically exits from the LEARN mode. Advanced version Information 93