Marantz RC9500 RC9500 User Manual - Page 65

DFU RC9500 Ver1_2.qxd 5/28/2004 10:33 AM Page 65 Troubleshooting The TV goes blank or the input source changes „ The buttons in the Device Overview page might be programmed to switch the input source. Select the device without issuing IR codes using the "No IR" function. (page 8) The configuration file is corrupted „ When this very unlikely event occurs, you can use Wizz.it 9 to download a new configuration file. Taken into account that all your customized commands, devices, and macros will be lost and you will have to reprogram your RC9500. The "Revert" function on the third Setup page is also available to get back the last downloaded configuration file. Error messages „ If one of the following error messages occurs, please try to update the firmware. The firmware updater can be found at www.marantz.com. z Can't open configuration file z Configuration file error z No configuration file found z Invalid configuration file version Tip The bulletin boards and friendly users at www.remotecentral.com can often give you help with problems. User Guide Recharging Problems The batteries won't recharge „ Make sure you are using the rechargeable battery pack, the docking station (DS9500) and the power adaptor supplied with your RC9500. „ Make sure the battery pack is installed properly in your RC9500. (see page 4) The indicator LEDs on the docking station flashe „ Check if the contacts on the docking station are clean and free of obstructions. „ Make sure the RC9500 lies properly on the docking station. „ Make sure the battery pack is properly installed. (see page 4) 61