Home » Maytag Manuals » Laundry Dryers » Maytag MEDX550XW » Manual Viewer

Maytag MEDX550XW Installation Instructions

Maytag MEDX550XW Manual

View all Maytag MEDX550XW manuals

Add to My Manuals
Save this manual to your list of manuals

Maytag MEDX550XW manual content summary:

Maytag MEDX550XW | Installation Instructions - Page 1
Electric Dryer Installation Instructions 27" Wide Models - U.S.A. Only Para obtener acceso al manual de uso y cuidado en español, o para obtener información adicional acerca de su producto, visite: www.whirlpool.com Tenga listo su número de modelo completo.
Maytag MEDX550XW | Installation Instructions - Page 2
DRYER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and don't immediately follow instructions. WARNING You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what
Maytag MEDX550XW | Installation Instructions - Page 3
Requirements" before purchasing parts. Mobile home installations require metal exhaust system hardware, available for purchase from the dealer from whom you purchased your dryer. For further information, please reference the "Assistance or Service" section of the Dryer User Instructions. If using
Maytag MEDX550XW | Installation Instructions - Page 4
to support the total weight (dryer and load) of 200 lbs. (90.7 kg). The combined weight of a companion appliance should also be considered. ■■ Level floor with maximum slope of 1" (25 mm) under entire dryer. (If slope is greater than 1" [25 mm], install Extended Dryer Feet Kit, Part Number 279810
Maytag MEDX550XW | Installation Instructions - Page 5
To properly install your dryer, you must determine the type of electrical connection you will be using and follow the instructions provided for cord, rated 120/240 volt minimum. The cord should be type SRD or SRDT and be at least 4 ft. (1.22 m) long. The wires that connect to the dryer must end
Maytag MEDX550XW | Installation Instructions - Page 6
people to move and install dryer. Failure to do so can result in back or other injury. diamond marking 1. Prepare dryer for leveling legs visible. Now stand the dryer on its feet. Slide the dryer until it is close to its final location. Leave enough room for electrical connection and to connect
Maytag MEDX550XW | Installation Instructions - Page 7
Wire WARNING WARNING Fire Hazard use a new ul listed 30 amp power supply cord. use a ul listed strain relief. Disconnect power before making electrical connections. Connect neutral wire (white or center wire) to center terminal (silver). Ground wire (green or bare wire) must be connected to green
Maytag MEDX550XW | Installation Instructions - Page 8
Power Supply Cord Connection IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit the use of 3-wire connections. strain relief. The strain relief should have a tight fit with the dryer cabinet and be in a horizontal position. Do not further tighten strain
Maytag MEDX550XW | Installation Instructions - Page 9
screw B Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to Venting Requirements. Remove center, silver-colored terminal block screw (B). 4. Connect
Maytag MEDX550XW | Installation Instructions - Page 10
Wire Connection IMPORTANT: A 4-wire connection is required for mobile homes and where local codes do not permit 3-wire connections. A to strain relief (127 5" mm) Direct wire cable must have 5 ft. (1.52 m) of extra length so dryer may be moved if needed. Strip 5" (127 mm) of outer covering
Maytag MEDX550XW | Installation Instructions - Page 11
center screw of terminal block (B). Squeeze hooked ends together and tighten screw. 7. Connect ground wire (893m½m" ) Direct wire cable must have 5 ft. (1.52 m) of extra length so dryer may be moved if needed. Strip 31/2" (89 mm) of outer covering from end of cable. Strip insulation back 1" (25 mm
Maytag MEDX550XW | Installation Instructions - Page 12
block screws (hooks facing right). Squeeze hooked ends together and tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to Venting Requirements. Optional 3-wire Connection You must verify with a qualified electrician
Maytag MEDX550XW | Installation Instructions - Page 13
supported in final dryer location. ■■ Remove excess to avoid sagging and kinking that may result in reduced airflow and poor performance. ■■ Do not install or flexible metal vents. Review Vent system chart and if necessary, modify existing vent system to achieve best drying performance. Good Better
Maytag MEDX550XW | Installation Instructions - Page 14
in many varieties. Select the type best for your installation. Two close-clearance installations are shown. Refer to the manufacturer's instructions. C D E A F G Over-The-Top installation (also available with one offset elbow) B A. Dryer B. Elbow C. Wall D. Exhaust hood E. Clamps I H F. Rigid
Maytag MEDX550XW | Installation Instructions - Page 15
not terminate beneath the mobile home. Terminate the exhaust vent outside. Install Vent System 1. Install exhaust hood 12" min. (305 mm) Determine vent path: ■■ Select route that will provide straightest and most direct path outdoors. ■■ Plan installation to use fewest number of elbows and turns
Maytag MEDX550XW | Installation Instructions - Page 16
Care Guide. q Set the dryer on a full heat cycle (not an air cycle) for 20 minutes and start the dryer. If the dryer will not start, check the following: ■■ Controls are set in a running or "On" position. ■■ Start button has been pushed firmly. ■■ Dryer is plugged into an outlet and/or electrical
Maytag MEDX550XW | Installation Instructions - Page 17
from hinge screws as they are different sizes. Holding door over towel on dryer, grasp sides of outer door and lift to separate it from inner door dryer cabinet are in large part of hinge slot. Pull door forward off screws. Set door (handle side up) on top of dryer. Remove top screws from dryer
Maytag MEDX550XW | Installation Instructions - Page 18
. 10. Insert screws in hinge holes on dryer cabinet NOTE: 2 people maybe needed to reinstall door. Insert screws into the bottom holes alignment. Troubleshooting See the Use and Care Guide or visit our website and reference Frequently Asked Questions to possibly avoid the 18 cost of a service call.
Maytag MEDX550XW | Installation Instructions - Page 19
Notes 19
Maytag MEDX550XW | Installation Instructions - Page 20
W10096988A W10306460A-SP 2©02010 Whirlpool Corporation. All rights reserved ® Registered Trademark/TM Trademark of Whirlpool, U.S.A. 2/10 Printed in U.S.A.