Maytag MGC6430BDB Installation Manual

Maytag MGC6430BDB - 30" Gas Cooktop Manual

Maytag MGC6430BDB manual content summary:

  • Maytag MGC6430BDB | Installation Manual - Page 1
    1/16 9.7 + 0.2 H 151/4 + 1/16 38.7 + 0.2 CUTOUT DIMENSIONS ARE CRITICAL SPECIAL WARNING: IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE, MAINTENANCE OR USE OF RANGE CAN RESULT IN SERIOUS INJURY OR PROPERTY DAMAGE. NOTICE TO INSTALLER: Leave these instructions with the appliance. NOTICE TO
  • Maytag MGC6430BDB | Installation Manual - Page 2
    must be supported within 3" (7.62 cm) of cutout. Installing Cabinetry Over Your Maytag Cooktop A = 30" (76.2 Gas. If LP gas is the fuel of choice, follow the conversion to LP procedure found in the installation instructions. [] Test all external connections for gas leaks. Never test for gas
  • Maytag MGC6430BDB | Installation Manual - Page 3
    service technician before attempting to operate the cooktop on that gas. Natural gas instructed under paragraph 1, page 4. • If this unit is to be installed over a Maytag Model MEW6500 or MEW5500 Series Electric Wall Oven proceed as instructed under paragraph 2, page 5. NOTE: In Canada, gas
  • Maytag MGC6430BDB | Installation Manual - Page 4
    Connecting Appliance To Gas Supply A QUALIFIED SERVICE TECHNICIAN OR GAS APPLIANCE INSTALLER MUST MAKE THE GAS SUPPLY CONNECTION. Leak testing of the appliance shall be conducted by the installer according to the instructions given. Gas supply piping MUST conform to all local, municipal and state
  • Maytag MGC6430BDB | Installation Manual - Page 5
    2. IF THIS UNIT WILL HAVE A MAYTAG MODEL MEW6500 or MEW5500 SERIES ELECTRIC WALL OVEN INSTALLED BELOW THIS COOKTOP. NOTE 1 : This appliance and its gas and electrical supply sources must be installed before the wall oven is installed. See illustration (Electrical Wiring Information - page 7; figure
  • Maytag MGC6430BDB | Installation Manual - Page 6
    Alternative Piping Methods To Connect Appliance To Gas Supply A TRAINED SERVICE TECHNICIAN OR GAS APPLIANCE INSTALLER MUST MAKE THE GAS SUPPLY CONNECTION. Leak testing of the appliance shall be conducted by the installer according to the instructions given, Unless prohibited by local codes or
  • Maytag MGC6430BDB | Installation Manual - Page 7
    through the oven's floor support shelf and, if necessary, through the slats supporting the shelf. The clearance WARNING Electrical Grounding Instructions This appliance is equipped SERVICING THE APPLIANCE. DISCONSUPPLY BEFORE 3 1/2" (8.89 cm)WIDE SLATS WHEN A WALL OVEN IS INSTALLED BELOW 30" MODEL
  • Maytag MGC6430BDB | Installation Manual - Page 8
    For Use With LP Gas WARNING Propane conversion is to be performed by a MAYTAG AUTHORIZED SERVICER (or other qualified agency) in accordance with the manufacturer's instructions and all codes and requirements of the authority having jurisdiction. Failure to follow instructions could result in serious
  • Maytag MGC6430BDB | Installation Manual - Page 9
    installed review gas. To set for use with LP proceed as follows: 1. Remove control knob from valve stem. CAUTION: NEVER USE A METAL BLADE TO PRY KNOB OFF: IF KNOB Replace rubber grommet and control knob. 7. Repeat for remaining burners. FLAME APPEARANCE AT HI AND LO KNOB FIGURE 13 KNOB HOLE _ (KNOB
  • Maytag MGC6430BDB | Installation Manual - Page 10
    With Natural Gas 4 BURNER MODEL (30" WIDE) Electrical powerWanAd RgaNs mINusGt be turned off prior to conversion. If this appliance has been converted for use with LP gas, each of the following modifications must be performed to convert the unit back to natural gas. A. REPLACE ALL ORIFICE SPUDS
  • Maytag MGC6430BDB | Installation Manual - Page 11
    knobs. The knob services of a qualified service technician. Some yellow tipping on LP gas is normal. Specified input rates are as shown in figures 16 and 17 below. 4 BURNER MODEL (30 650 FIGURE17 ) ARTff 9215-213-0 MAYTAG 30" INPUT RATES- NATURALGAS / LP GAS (BTU/HR) BURNERLOCATION Hi Lo
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11

SEALEDGAS COOKTOPS
Models:
MGC6430
&
MGC6536
IMPORTANT:
Dimensions
Shown
in Both
Inches
and Centimeters.
IMPORTANT:
Be sure the appliance
being installed
is equipped
for the gas to be supplied.
Refer to serial plate on
underside of burner box for this information.
Do not attempt to convert this appliance for use with a gas other than the type
specified.
DIMENSIONS
inches
cm
A
28 1/2
+
1/16
72.4
+
0.2
B
19 15/16 +
1/16
50.6
+
0.2
C
21/8
+
1/16
5.4
+
0.2
D
51/4
+
1/16
13.3
+
0.2
E
30
+
1/16
76.2
+
0.2
F
21 1/2
+
1/16
54.6
+
0.2
G
313/16
+
1/16
9.7
+
0.2
H
12 1/4
+
1/16
31.1
+
0.2
DIMENSIONS
inches
cm
A
34 1/2
+
1/16
87.6
+
0.2
B
19 15/16 +
1/16
50.6
+
0.2
C
21/8
+
1/16
5.4
+
0.2
D
51/4
+
1/16
13.3
+
0.2
E
36
+
1/16
91.4
+
0.2
F
21
+
1/16
53.3
+
0.2
G
313/16
+
1/16
9.7
+
0.2
H
151/4
+
1/16
38.7
+
0.2
CUTOUT
DIMENSIONS
ARE
CRITICAL
SPECIAL
WARNING:
IMPROPER
INSTALLATION,
ADJUSTMENT,
ALTERATION,
SERVICE,
MAINTENANCE
OR
USE
OF
RANGE
CAN
RESULT
IN SERIOUS
INJURY
OR
PROPERTY
DAMAGE.
NOTICE
TO
INSTALLER:
Leave
these
instructions
with
the
appliance.
NOTICE
TO
CONSUMER:
Retain
these
instructions
for
future
reference.
8101
P524-60
(01-03-00)