Maytag MGR7665WS Installation Instructions
Maytag MGR7665WS - 30" Ing Gas Range Manual
 |
UPC - 883049176529
View all Maytag MGR7665WS manuals
Add to My Manuals
Save this manual to your list of manuals |
Maytag MGR7665WS manual content summary:
- Maytag MGR7665WS | Installation Instructions - Page 1
INSTRUCTIONS 8 Unpack Range ...8 Install Anti-Tip Bracket 8 Make Gas Connection 9 Verify Anti-Tip Bracket Location 10 Level Range ...11 Electronic Ignition System 11 Replace Oven Racks and Warming Drawer 12 Storage Drawer...13 Complete Installation 13 GAS CONVERSIONS 14 LP Gas Conversion - Maytag MGR7665WS | Installation Instructions - Page 2
from a neighbor's phone. Follow the gas supplier's instructions. • If you cannot reach your gas supplier, call the fire department. - Installation and service must be performed by a qualified installer, service agency or the gas supplier. WARNING: Gas leaks cannot always be detected by smell - Maytag MGR7665WS | Installation Instructions - Page 3
handle type. ■ A flexible gas connector, when used, must not exceed 3 feet. WARNING Tip Over Hazard A child or adult can tip the range and be killed. Connect anti-tip bracket to rear range foot. Reconnect the anti-tip bracket, if the range is moved. Failure to follow these instructions can result in - Maytag MGR7665WS | Installation Instructions - Page 4
■ It is the installer's responsibility to comply with installation clearances specified on the model/serial rating plate. The model/serial rating plate is located on the oven frame behind the top left side of the oven door. ■ The range should be located for convenient use in the kitchen. ■ Recessed - Maytag MGR7665WS | Installation Instructions - Page 5
Model/serial rating plate (located on the oven frame behind the top left side of the oven door) *Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs. Cabinet Dimensions Cabinet opening dimensions mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper. 30" (76 - Maytag MGR7665WS | Installation Instructions - Page 6
instructions. Type of Gas Natural gas: This range is design-certified by CSA International for use with Natural gas or, after proper conversion, for use with LP gas. ■ This range is factory set for use with Natural gas. See "Gas Conversions" section. The model/serial rating plate located on the oven - Maytag MGR7665WS | Installation Instructions - Page 7
must be equipped with a manual shutoff valve. This valve should be located in the same room but external to the range opening, such as an adjacent model/serial rating plate. Line pressure testing above ½ psi gauge (14" WCP) The range and its individual shutoff valve must be disconnected from the gas - Maytag MGR7665WS | Installation Instructions - Page 8
mounting holes through your type of floor covering. Before moving range, slide range onto shipping base, cardboard or hardboard. 1. Remove template from the anti-tip bracket kit (found inside the oven cavity) or from the back of this manual. 2. Place template on the floor in cabinet opening so that - Maytag MGR7665WS | Installation Instructions - Page 9
for use with LP gas to all pipe thread connections. 2. Using a pipe wrench to tighten, connect the gas supply to the range. B C D A F E J A. Gas pressure regulator B. 90° elbow (must have ½" male pipe thread) C. Nipple D. Union E. Black iron pipe I H G F. Manual gas shutoff valve G. ½" or - Maytag MGR7665WS | Installation Instructions - Page 10
See "Storage Drawer" section. On models with a warming drawer, the rear leg cannot be seen by removing the warming drawer. It will be necessary to view the rear foot from outside the range. A. Gas pressure regulator shutoff valve 2. Open the manual shutoff valve in the gas supply line. The valve is - Maytag MGR7665WS | Installation Instructions - Page 11
the gas shutoff valves are set to the "open" position. ■ Check that burner caps are properly positioned on burner bases. Repeat start-up. If a burner does not light at this point, turn the control knobs to "Off" and contact your dealer or authorized service company for assistance. B A. Low flame - Maytag MGR7665WS | Installation Instructions - Page 12
the Use and Care Guide for proper operation of the oven controls. Adjust Oven Bake Burner Flame (if needed) 1. On models with a warming drawer, CANCEL/OFF when finished. Replace Oven Racks and Warming Drawer Replace oven racks in oven cavity. Replace warming drawer. To Replace Warming Drawer: 1. - Maytag MGR7665WS | Installation Instructions - Page 13
and Care Guide for specific instruction on range operation. If range does not operate, check the following: ■ Household fuse is intact and tight, or circuit breaker has not tripped. ■ Range is plugged into a grounded 3 prong outlet. ■ Electrical supply is connected. ■ See "Troubleshooting" in the - Maytag MGR7665WS | Installation Instructions - Page 14
GAS CONVERSIONS Gas conversions from Natural gas to LP gas or from LP gas to Natural gas must be done by a qualified installer. To Convert Gas Pressure Regulator WARNING 1. Remove storage drawer or warming drawer. See "Replace Oven Racks and Warming Drawer" section. 2. Locate gas pressure - Maytag MGR7665WS | Installation Instructions - Page 15
on the back of the range near the gas inlet. Gas orifice spuds are stamped with a number, marked with 1 color dot, and have a groove in the hex area. Replace the Natural gas orifice spud with the correct LP gas orifice spud. A A. Orifice hood B. Pin To Convert Oven Broil Burner Use a ½" combination - Maytag MGR7665WS | Installation Instructions - Page 16
. LP gas flames have a slightly yellow tip. 3. Refer to "Complete Installation" in the "Installation Instructions" section of this manual to complete this procedure. Natural Gas Conversion WARNING To Convert Gas Pressure Regulator 1. Remove storage drawer or warming drawer. See "Replace Oven Racks - Maytag MGR7665WS | Installation Instructions - Page 17
location. 5. Place LP gas orifice spuds in plastic parts bag for future use and keep with package containing literature. 6. Replace the burner base using both screws. 7. Replace burner cap. 8. Repeat steps 1-7 for the remaining burners. To Convert Oven Bake Burner 1. Remove oven racks. 2. Use - Maytag MGR7665WS | Installation Instructions - Page 18
cannot be properly adjusted if this conversion is not made. See "Adjust Oven Broil Burner Flame" in the "Electronic Ignition System" section. Complete Installation 1. Refer to the "Make Gas Connection" section for properly connecting the range to the gas supply. 2. Refer to the "Electronic Ignition - Maytag MGR7665WS | Installation Instructions - Page 19
Left edge ANTI-TIP BRACKET TEMPLATE Cut on dotted lines and place the left edge against the left side cabinet and the top edge against the rear wall. Top edge 19 - Maytag MGR7665WS | Installation Instructions - Page 20
W10196161E © 2011. All rights reserved. 1/11 Printed in U.S.A.
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
 |
 |
INSTALLATION INSTRUCTIONS
30" (76.2 CM) FREESTANDING GAS RANGES
Table of Contents
RANGE SAFETY
..........................................................................................................
2
INSTALLATION REQUIREMENTS
.............................................................................
4
Tools and Parts
.........................................................................................................
4
Location Requirements
.............................................................................................
4
Electrical Requirements
............................................................................................
6
Gas Supply Requirements
........................................................................................
6
INSTALLATION INSTRUCTIONS
...............................................................................
8
Unpack Range
..........................................................................................................
8
Install Anti-Tip Bracket
.............................................................................................
8
Make Gas Connection
..............................................................................................
9
Verify Anti-Tip Bracket Location
.............................................................................
10
Level Range
............................................................................................................
11
Electronic Ignition System
......................................................................................
11
Replace Oven Racks and Warming Drawer
...........................................................
12
Storage Drawer
.......................................................................................................
13
Complete Installation
..............................................................................................
13
GAS CONVERSIONS
................................................................................................
14
LP Gas Conversion
.................................................................................................
14
Natural Gas Conversion
..........................................................................................
16
ANTI-TIP BRACKET TEMPLATE
............................................................................
19
IMPORTANT:
Save for local inspector's use.
Installer:
Leave installation instructions with the homeowner.
Homeowner:
Keep installation instructions for future reference.
W10196161E