Maytag MMV1174FZ Installation Guide
Maytag MMV1174FZ Manual
 |
View all Maytag MMV1174FZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Maytag MMV1174FZ manual content summary:
- Maytag MMV1174FZ | Installation Guide - Page 1
particular model may differ slightly from the illustration in these installation instructions. Table of Contents MICROWAVE HOOD COMBINATION SAFETY 1 INSTALLATION REQUIREMENTS 2 Tools and Parts 2 Remove Cardboard Template 2 Location Requirements 2 Product Dimensions 3 Electrical Requirements - Maytag MMV1174FZ | Installation Guide - Page 2
refer to it during the "Mark Rear Wall" part of installation. Location Requirements Check the opening where the microwave oven will be installed. The location must provide: ■■ Minimum installation dimensions. See "Installation Dimensions" illustration. ■■ Minimum one 2" x 4" (50.8 x 101.6 mm) wood - Maytag MMV1174FZ | Installation Guide - Page 3
if the grounding instructions are not completely understood, or if doubt exists as to whether the microwave oven is properly grounded. Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the microwave oven. SAVE THESE - Maytag MMV1174FZ | Installation Guide - Page 4
INSTALLATION INSTRUCTIONS Remove Mounting Plate Depending on your model, the mounting plate may be in the foam packaging, or it may be attached to the back of the microwave oven. NOTE: To avoid possible damage to the work surface, cover the work surface. 1. Remove any remaining contents from the - Maytag MMV1174FZ | Installation Guide - Page 5
. Make sure damper plate tabs are inserted into the slots in the top of the microwave oven. A B C 6. Reattach blower motor to back of microwave oven with 2 screws removed in Step 3 of "Wall Venting Installation Only." Securely tighten screws. NOTE: If blower motor is not correctly oriented, the - Maytag MMV1174FZ | Installation Guide - Page 6
studs exist within the cabinet opening, do not install the microwave oven. See illustrations in "Possible Wall Stud Configurations holes (on mounting plate) B. Cabinet opening vertical centerline C. Wall stud centerlines D. Holes for lag screws E. Support tabs F. Mounting plate center markers 6 - Maytag MMV1174FZ | Installation Guide - Page 7
Mark Rear Wall The microwave oven must be installed on a minimum of 1 wall stud, preferably 2, using a minimum of . They must each be 14¹⁄₈" (35.9 cm) from the centerline. 5. With the support tabs facing forward (see illustrations in "Locate Wall Stud(s)" section), align the mounting plate center - Maytag MMV1174FZ | Installation Guide - Page 8
1 wall stud as well as at both ends. 1. With the support tabs of the mounting plate facing forward, insert 3/16-24 x guides. ■■ If the wall behind the microwave oven (as installed) has a partial wall covering (for example, tile backsplash), be sure the "Rear Wall" arrows align to the thickest part - Maytag MMV1174FZ | Installation Guide - Page 9
from the microwave oven. A B C D Install the Microwave Oven WARNING Excessive Weight Hazard Use two or more people to move and install microwave oven. Failure sheet metal screws. A B A. Mounting plate B. Support tabs 4. With front of microwave oven still tilted, thread power supply cord through - Maytag MMV1174FZ | Installation Guide - Page 10
vent fan. 5. If the microwave oven does not operate: ■■ problem continues, call an electrician. ■■ Check that the power supply cord is plugged into a grounded 3 prong outlet. ■■ See the User Instructions for troubleshooting information. Installation is now complete. Save Installation Instructions - Maytag MMV1174FZ | Installation Guide - Page 11
This section is intended for architectural designer and builder/ contractor reference only. NOTES: ■■ Vent materials needed for installation are not provided with microwave hood combination. ■■ We do not recommend using a flexible metal vent. ■■ To avoid possible product damage, be sure - Maytag MMV1174FZ | Installation Guide - Page 12
cm) wide. Replacement Parts If any of the installation hardware needs to be replaced, call us at our toll free number listed in the User Guide. Following is a list of available replacement parts. You will need your model number located on the front facing of the microwave oven opening, behind the
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
 |
 |
MICROWAVE HOOD COMBINATION
INSTALLATION INSTRUCTIONS
This product is suitable for use above electric or gas cooking products up to and including 36" (91.4 cm) wide. See “Installation
Requirements” section for further notes.
These installation instructions cover different models. The appearance of your particular model may differ slightly from the illustration
in these installation instructions.
MICROWAVE HOOD COMBINATION SAFETY
You can be killed or seriously injured if you don't immediately
You
can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING
MICROWAVE HOOD COMBINATION SAFETY
............................
1
INSTALLATION REQUIREMENTS
.................................................
2
Tools and Parts
.............................................................................
2
Remove Cardboard Template
......................................................
2
Location Requirements
................................................................
2
Product Dimensions
.....................................................................
3
Electrical Requirements
...............................................................
3
INSTALLATION INSTRUCTIONS
...................................................
4
Remove Mounting Plate
...............................................................
4
Rotate Blower Motor
....................................................................
4
Locate Wall Stud(s)
......................................................................
6
Mark Rear Wall
.............................................................................
7
Drill Holes in Rear Wall
.................................................................
7
Attach Mounting Plate to Wall
.....................................................
8
Prepare Upper Cabinet
................................................................
8
Install Damper Assembly
.............................................................
9
Install the Microwave Oven
..........................................................
9
Complete Installation
.................................................................
10
VENTING DESIGN SPECIFICATIONS
.........................................
11
ASSISTANCE
................................................................................
12
Replacement Parts
.....................................................................
12
Accessories
................................................................................
12
Table of Contents
W10823831A