Miele DA 1280 Operating instructions/Installation instructions
Miele DA 1280 Manual
View all Miele DA 1280 manuals
Add to My Manuals
Save this manual to your list of manuals |
Miele DA 1280 manual content summary:
- Miele DA 1280 | Operating instructions/Installation instructions - Page 1
Operating and Installation Instructions Ventilation hood To prevent accidents and damage to the appliance, you must read these instructions before installing the appliance and using it for the first time. en-US M.-Nr. 10 532 790 - Miele DA 1280 | Operating instructions/Installation instructions - Page 2
Contents IMPORTANT SAFETY INSTRUCTIONS 3 Caring for the environment 12 Description of functions 13 Guide to the appliance 14 Operation 22 Installation...23 Before installation 23 Installation parts ...24 Appliance dimensions 26 Distance between cooktop and ventilation hood (S 27 Installation - Miele DA 1280 | Operating instructions/Installation instructions - Page 3
can lead to personal injury and material damage. Read all instructions before installing or using the appliance for the first time. Only use for residential use only. Use only as described in these operating instructions. This ventilation hood is not intended for outdoor use. It must only be - Miele DA 1280 | Operating instructions/Installation instructions - Page 4
safety regulations and the provided installation instructions. Contact Miele's Technical Service Department for examination, repair or adjustment. Repairs and other work by unauthorized persons could be dangerous and may void the warranty. A damaged ventilation hood can be dangerous. Always check - Miele DA 1280 | Operating instructions/Installation instructions - Page 5
IMPORTANT SAFETY INSTRUCTIONS Be certain your appliance is properly installed and grounded by hood is operated simultaneously with devices that burn gas or other fuels. Only open the housing as described in the enclosed "Installation diagram" and in the "Cleaning and care" section of this manual - Miele DA 1280 | Operating instructions/Installation instructions - Page 6
IMPORTANT SAFETY INSTRUCTIONS If the power cord is damaged, it must only be replaced by a qualified service technician. During installation, maintenance, and repair work, the ventilation hood must be disconnected from the electrical supply. It is only completely isolated from the electricity - Miele DA 1280 | Operating instructions/Installation instructions - Page 7
IMPORTANT SAFETY INSTRUCTIONS - a) SMOTHER FLAMES with a close fitting lid, cookie sheet, or cookware. - Avoid overheating the cookware (e.g., when cooking with a wok). Always turn the ventilation hood on whenever a burner is in use to prevent damage from condensation. Overheated oil and fat can - Miele DA 1280 | Operating instructions/Installation instructions - Page 8
in place. There is a risk of fire if cleaning is not completed according to the instructions in this manual. Please note that the heat rising from the stovetop during cooking can cause the ventilation hood to become very hot. Do not touch the housing or the grease filters until the ventilation - Miele DA 1280 | Operating instructions/Installation instructions - Page 9
Insufficient distance between the cooking appliance and the ventilation hood can result in damage to the hood. The minimum safety distances between the appliance and the bottom of the ventilation hood specified in the "Installation" section must be maintained, unless the appliance's manufacturer has - Miele DA 1280 | Operating instructions/Installation instructions - Page 10
the ventilation hood. Metal parts can have sharp edges which may cause injury. Wear gloves to protect your hands from being cut. When installing the exhaust duct, only use pipes or tubes made of non-flammable material. These can be obtained from your Miele dealer or from Miele Technical Service - Miele DA 1280 | Operating instructions/Installation instructions - Page 11
IMPORTANT SAFETY INSTRUCTIONS Cleaning and care Never use a steam cleaner to clean the ventilation hood. The steam can reach the electrical components and cause a short circuit. Accessories Use only genuine original Miele parts. If parts or accessories from other manufacturers are used, the - Miele DA 1280 | Operating instructions/Installation instructions - Page 12
household waste and follow local regulations on proper disposal. Consult with local authorities, dealers or Miele in order to dispose of and recycle electrical and electronic appliances. Miele assumes no responsibility for deleting any personal data left on the appliance being disposed. Please - Miele DA 1280 | Operating instructions/Installation instructions - Page 13
flap in the ducting prevents the exchange of inside and outside air from occurring when the ventilation hood is not in use. The flap is closed when the ventilation hood is turned off. When the ventilation hood is turned on, the non-return flap opens so that the exhaust air can be transported - Miele DA 1280 | Operating instructions/Installation instructions - Page 14
Guide to the appliance 14 - Miele DA 1280 | Operating instructions/Installation instructions - Page 15
Guide to the appliance a Control panel b LED ClearView lighting c OdorFree Charcoal Filter Optional accessory for recirculation mode d Cover for the charcoal filter compartment e Grease filters f Vent - Miele DA 1280 | Operating instructions/Installation instructions - Page 16
Operation Switch on the blower Power levels 1 to 3 are available for light to heavy cooking vapors and odors. If heavy cooking vapors and odors occur temporarily, e.g., during frying, select stage B as booster level. Use the blower switch to turn on the blower and select the appropriate power - Miele DA 1280 | Operating instructions/Installation instructions - Page 17
necessary. - When a large volume of cooking vapors are being produced, switch to a high power level in good time. This is more efficient than operating the hood for longer to try to capture cooking vapors that have already been distributed throughout the kitchen. - Make sure that you switch off the - Miele DA 1280 | Operating instructions/Installation instructions - Page 18
RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Before cleaning or servicing the hood, disconnect it from the power supply, see "IMPORTANT SAFETY INSTRUCTIONS". Stainless steel housing General information The surfaces and control buttons are susceptible to scratching and - Miele DA 1280 | Operating instructions/Installation instructions - Page 19
. Remove any dirt or debris immediately. Observe the general cleaning instructions contained in this chapter. Do not use a stainless steel cleaner to in kitchen vapors (fat, dust, etc.), thereby preventing the ventilation hood from becoming dirty. A dirty filter is a fire hazard! Cleaning - Miele DA 1280 | Operating instructions/Installation instructions - Page 20
dishwashing detergent. Select a program with a wash temperature between 120°F (50°C) and 150°F (65°C). In a Miele dishwasher use the "Normal" program. If the filters have been installed incorrectly, you can insert a small screwdriver into the slit to disengage the locking clip. Depending on - Miele DA 1280 | Operating instructions/Installation instructions - Page 21
the grease filters. Charcoal filters are available to order via the Miele Webstore, Miele Service (see end of this booklet for contact details) or directly from Miele. Installing/replacing the OdorFree Charcoal Filter To install or replace the OdorFree Charcoal Filter, the grease filters must - Miele DA 1280 | Operating instructions/Installation instructions - Page 22
Miele. Turn off the blower and the lighting. Remove the grease filters. Disconnect the hood from the electrical supply before replacing the bulbs (see "IMPORTANT SAFETY INSTRUCTIONS and pull it out. Install the new bulb. Observe the manufacturer's instructions. Slightly loosen the screw - Miele DA 1280 | Operating instructions/Installation instructions - Page 23
Before installation Before installing the appliance, read all of the information contained in this chapter and also in the "IMPORTANT SAFETY INSTRUCTIONS" section. Installation 23 - Miele DA 1280 | Operating instructions/Installation instructions - Page 24
Installation Installation parts 24 - Miele DA 1280 | Operating instructions/Installation instructions - Page 25
recirculation mode). c 2 Brackets for securing the hood to the wall (not required when installed underneath the wall unit). d 1 Drilling template Make sure that the wall can support the load. 4 Self-tapping screws ³/₁₆" x 1 4.2 x 30 mm) for securing the ventilation hood onto the wall unit (from - Miele DA 1280 | Operating instructions/Installation instructions - Page 26
Installation Appliance dimensions 26 - Miele DA 1280 | Operating instructions/Installation instructions - Page 27
of the hood. Please also observe the information contained in the "IMPORTANT SAFETY INSTRUCTIONS" section. Cooking BTU/hr (8.1 kW) Single Burner Gas Cooktops > 27,600 BTU/hr (8.1 kW) Minimum distance S Miele appliance Non-Miele appliance 24" (610 mm) 26" (660 mm) 26" (660 mm) 30" (760 mm) - Miele DA 1280 | Operating instructions/Installation instructions - Page 28
must be easily accessible. The ventilation hood should be easy to reach and disassemble in case a service call is necessary. This should be The film can be peeled off easily. Deflector A deflector is installed in the rear of the hood. Its position depends on operating mode. During the vented mode, - Miele DA 1280 | Operating instructions/Installation instructions - Page 29
Check the installation position of the deflector. Remove the deflector if necessary and turn it as appropriate recirculation mode, attach the cover foil to the opening at the back of the range hood. The foil comes with the OdorFree Charcoal Filter (optional accessory). Recirculation mode 29 - Miele DA 1280 | Operating instructions/Installation instructions - Page 30
shown on the drilling template and the screws supplied. Incorrect attachment can lead to damage to the hood and could compromise electrical safety (e.g. electric shock). When selecting the installation position, ensure that the recirculation grille at the front of the appliance are not covered by - Miele DA 1280 | Operating instructions/Installation instructions - Page 31
Installation Attachment from below As described previously, Miele recommends the attachment from above. Should it not be possible to proceed with the attachment from above, the hood can also be mounted to the cabinet's floor from below. The provided screws are intended for the attachment of the hood - Miele DA 1280 | Operating instructions/Installation instructions - Page 32
Wall installation You also have the option of mounting the range hood to the wall by means of two brackets. Two mounting brackets are supplied for this purpose. Remove the guide plugs from the housing. Use the cover caps to close the holes (this also applies when mounting the hood from - Miele DA 1280 | Operating instructions/Installation instructions - Page 33
Installation Attach the mounting brackets to the wall, using the wall anchors and screws provided. The screws and plugs are designed for use in solid walls only. Use different fasteners for other wall construction types. Make sure that the wall can support the load. Removing the bulb: - Loosen - Miele DA 1280 | Operating instructions/Installation instructions - Page 34
to size with. When using 5" (125 mm) exhaust ducting, install the exhaust socket as is. Tighten the two screws on the right and left hand sides of the back of the appliance. This will adjust the angle and secure the ventilation hood. Refit the bulbs. Reinsert the grease filters. Insert - Miele DA 1280 | Operating instructions/Installation instructions - Page 35
" and "IMPORTANT SAFETY INSTRUCTIONS" before connecting to the electricity supply. Connect the hood to the electrical supply. hood. - In recirculation mode, the air should come out of the recirculation grille at the front of the hood. If this does not happen, the deflector is not installed - Miele DA 1280 | Operating instructions/Installation instructions - Page 36
70) and local safety regulations. Installation, repairs and other work by unqualified hood. If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or call Miele's Technical Service Department. Grounding Instructions - Miele DA 1280 | Operating instructions/Installation instructions - Page 37
the risk of fire, only use metal ductwork. Please read and follow the "IMPORTANT SAFETY INSTRUCTIONS" to reduce the risk of personal injury. Follow all local building codes when installing the hood. Only use smooth pipes or flexible duct hoses made from noncombustible materials for exhaust ductwork - Miele DA 1280 | Operating instructions/Installation instructions - Page 38
traps are available for exhaust ducts with a diameter of 5" (125 mm) or 6" (150 mm). When installing a condensate trap, make sure that it is positioned vertically and, if possible, directly above the hood outlet duct collar. The arrow on the housing indicates the direction of airflow. 38 - Miele DA 1280 | Operating instructions/Installation instructions - Page 39
that you cannot resolve on your own, please contact your Miele dealer or Miele Technical Service. The telephone number for Miele is listed at the back of these instructions. When contacting Miele, please state the model and serial number of your ventilation hood. These can be found on the data plate - Miele DA 1280 | Operating instructions/Installation instructions - Page 40
Technical data Blower motor LED ClearView lighting Total connected load Supply voltage, frequency Fuse Power cord length Weight DA 1260 DA 1280 Optional accessory for recirculation mode 1 OdorFree Charcoal Filter DKF 18-900 2 x 140 W 2 x 3 W 286 W 120 V AC, 60 Hz 15 A 2.5 ft (0.75 m) 24.6 lbs (11.2 - Miele DA 1280 | Operating instructions/Installation instructions - Page 41
- Miele DA 1280 | Operating instructions/Installation instructions - Page 42
- Miele DA 1280 | Operating instructions/Installation instructions - Page 43
419-4298 www.mieleusa.com Technical Service & Support Phone: 800-999-1360 Fax: 888-586-8056 [email protected] International Headquarters Miele & Cie. KG Carl-Miele-Straße 29 33332 Gütersloh Germany Canada Importer Miele Limited Headquarters and Miele Centre 161 Four Valley Drive Vaughan - Miele DA 1280 | Operating instructions/Installation instructions - Page 44
DA 1260, DA 1280 en-US M.-Nr. 10 532 790 / 02
Operating and Installation Instructions
Ventilation hood
To prevent accidents and damage to the appliance, you
must
read
these instructions before installing the appliance and using it for the first
time.
en-US
M.-Nr. 10 532 790