Miele DA 249 Operating manual
Miele DA 249 Manual
 |
View all Miele DA 249 manuals
Add to My Manuals
Save this manual to your list of manuals |
Miele DA 249 manual content summary:
- Miele DA 249 | Operating manual - Page 1
Operating and Installation Instructions Ventilation System DA 249-4 To prevent accidents and appliance damage, read these instructions before installation or use. en - US, CA M.-Nr. 07 781 040 - Miele DA 249 | Operating manual - Page 2
SAFETY INSTRUCTIONS 3 Functional description 7 Guide to the Ventilation System 8 Operation 10 Turning on the fan 10 Selecting the power level 10 Delayed Shut Down 12 Turning off the fan 12 Turning the lighting on/off 13 Dimming the lighting 13 Filter timers 14 Checking the filter timers - Miele DA 249 | Operating manual - Page 3
to any future user. Read these instructions carefully before installing or using the Ventilation System. ~ This appliance is intended for questions, contact Miele. ~ b) Before servicing or cleaning the appliance, switch power off at the service panel and lock the service disconnecting means - Miele DA 249 | Operating manual - Page 4
INSTRUCTIONS "Installation diagram" and in the "Cleaning and care" section of this manual. Under no circumstances should any other parts of turn the hood on when cooking at a high heat. ~ c) Clean the ventilation hood frequently. Grease should not be allowed to accumulate on the fan or filter. ~ - Miele DA 249 | Operating manual - Page 5
not overheat the cookware, e.g. when using a wok. The hood can be damaged due to excessive heat from the burners and the cookware. ~ Do not use the hood without the grease filters in place. ~ Do not use a steam cleaner to clean the hood. Steam could penetrate electrical components and cause a short - Miele DA 249 | Operating manual - Page 6
the bottom of the hood given in the "Appliance dimensions" section of this manual. If local building codes ventilating ductwork. ~ j) Seek professional advice before connecting an exhaust hood vent to an existing, inactive chimney or vent flue. ~ k) Any fittings, sealant, or materials used to install - Miele DA 249 | Operating manual - Page 7
is drawn through the decor panel, grease filter and an active charcoal filter. The filtered air is then recirculated back into the kitchen through a vent at the top of the hood's chimney. The recirculation mode requires an install kit and charcoal filter which are optional accessories. Before using - Miele DA 249 | Operating manual - Page 8
Guide to the Ventilation System 8 - Miele DA 249 | Operating manual - Page 9
Guide to the Ventilation System a Chimney extension b Recirculation vent For recirculation use with optional accessories c Chimney d Canopy e Overhead lighting f Active Charcoal Filter Available to purchase, for use in the recirculation mode. m Grease filter button The indicator next to the grease - Miele DA 249 | Operating manual - Page 10
Operation Turning on the fan ^ Press the On/Off button. The fan runs at power level "2". The On/Off indicator lights. Automatically switching back the Intensive power level The intensive level "4" can be programmed to automatically switch back to level "3" after 10 minutes. ^ Turn the fan and the - Miele DA 249 | Operating manual - Page 11
Level 3 operates at 80% capacity Level 4 operates at 100% capacity There will also be a slight decrease in airflow for hoods operated in recirculation mode due to the active charcoal filter. ^ To save the setting press the Delay Shut Down button. If the procedure is not saved within 4 minutes of - Miele DA 249 | Operating manual - Page 12
Operation Delayed Shut Down If odors or smoke remain in the kitchen after cooking has been completed, the Delayed Shut Down feature can be selected to allow the hood to continue running for either 5 or 15 minutes. Turning off the fan ^ Press the On/Off button to turn the fan off. The indicator - Miele DA 249 | Operating manual - Page 13
Operation Turning the lighting on/off The overhead lighting can be turned on and off independently of the fan. ^ Press the light button briefly to turn on the lighting. The light button indicator illuminates. ^ Press the light button briefly again to turn off the lighting. The light button - Miele DA 249 | Operating manual - Page 14
of fan operation. The indicator for the grease filter will light after 30 hours of operation. The grease filter must then be cleaned. After the grease filter have been cleaned and put in place, the grease filter timer must be reset. Checking the filter timers To check the percentage of time already - Miele DA 249 | Operating manual - Page 15
kitchen is only used occasionally. Otherwise grease which has accumulated over a long period of time will harden on the filters making cleaning more difficult. Reprogramming the grease filter timer The indicator for the grease filter filter button. ^ Press the Delayed Shut Down and grease filter - Miele DA 249 | Operating manual - Page 16
can not be used to exhaust fumes. The charcoal filter timer is not preset. Before using the hood in recirculation mode, the charcoal filter timer must be programmed. ^ Turn off the fan using the On/Off button. The indicator for the charcoal filter and one of the "-/+" indicators will flash. The lit - Miele DA 249 | Operating manual - Page 17
"Cleaning the casing" instructions. Stainless steel Stainless steel surfaces can be cleaned using a non-abrasive stainless steel cleaner. To help prevent resoiling, a conditioner for stainless steel can also be used. Apply sparingly with even pressure. ^ All external surfaces and controls can - Miele DA 249 | Operating manual - Page 18
Cleaning and Care Grease filter The decor panel and reusable metal grease filter remove solid particles from the vented kitchen air (grease, dust, etc). The grease filter is visible when the decor cover is removed. Removing the decor cover The grease filters should be cleaned every 3 - 4 weeks, - Miele DA 249 | Operating manual - Page 19
cause permanent discoloration of the filter surface. Performance of the filter will not be affected by this discoloration. ^ Angle the grease filter into position toward the front of the hood. ^ Once the front edge of the filter is in place, push up the rear of the filter so that both sides click - Miele DA 249 | Operating manual - Page 20
mode. Loosen the screw in the connector and remove. ^ Insert the new charcoal filter on an angle toward the front of the hood and then firmly press the rear in place. ^ Return the grease filter and decor cover. ^ When the active charcoal filter is installed for the first time, program the charcoal - Miele DA 249 | Operating manual - Page 21
when it no longer absorbs odors efficiently. The old charcoal filter can be disposed of in the household waste. ^ After replacing the charcoal filters, press and hold the charcoal filter button for about 3 seconds to reset the charcoal filter timer. The indicator light will go out. ^ If the charcoal - Miele DA 249 | Operating manual - Page 22
RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Before changing the light bulbs, disconnect the hood from the power supply, see "Important Safety Instructions". ^ Remove the decor cover, see "Cleaning and Care / Removing the decor cover". ^ Pull the old bulb out of its - Miele DA 249 | Operating manual - Page 23
by 5 years of worry free ownership. MieleCare is the only Extended Service Contract in the industry that guarantees repairs by a Miele Authorized Service Provider using genuine Miele parts. Only genuine Miele parts installed by factory trained professionals can guarantee the safety, reliability, and - Miele DA 249 | Operating manual - Page 24
24 - Miele DA 249 | Operating manual - Page 25
Installation Instructions Read these instructions and the "Important Safety Instructions" before installing this ventilation system. The installation steps are described in the enclosed "Installation Diagram". Leave these instructions with the appliance for the consumer/user. Information is subject - Miele DA 249 | Operating manual - Page 26
26 - Miele DA 249 | Operating manual - Page 27
Caring for the environment Disposal of packing material The cardboard box and packing materials protect the appliance during shipping. They have been designed to be biodegradable and recyclable. Please recycle. ,DANGER Ensure that any plastic wrappings, bags, etc., are disposed of safely and kept - Miele DA 249 | Operating manual - Page 28
Appliance dimensions 28 - Miele DA 249 | Operating manual - Page 29
installation are necessary. The installation procedure differs depending on the model and venting method. Before beginning the installation: ^ Read all instructions suitable to the kitchen's ceiling height, longer optional chimney extensions are available from your Miele dealer or Miele. To fit the - Miele DA 249 | Operating manual - Page 30
Wok) < 20,500 BTU (6 KW) All other gas cooktops Miele Cooktops Non-Miele Cooktops 24" (610 mm) 26" (660 mm) 26" (660 mm) 30" (760 mm) 26" (660 mm) 30" (760 mm) 30" (760 mm) - If several gas surfaces are installed under the hood, the total output must be considered when determining the minimum - Miele DA 249 | Operating manual - Page 31
required locations, a plywood backing (min. ½" (13 mm) thick) spanning at least two studs must be installed. Failure to adequately support the weight as stated may result in the ventilation system falling off the wall, causing personal injury and property damage. (If plywood backing is not needed - Miele DA 249 | Operating manual - Page 32
Installation 32 - Miele DA 249 | Operating manual - Page 33
of hand or other injury, avoid contact with sharp edges during the assembly and installation process. 8 large headed screws 5 x 40 mm for securing the retaining plates washers for securing the glass canopy. 1 screw cover Installation instruction diagram 1 lever for disassembling the chimney 33 - Miele DA 249 | Operating manual - Page 34
with a protective film to prevent scratching during transport. ^ Peel off the film before installing the casing parts. Dismantling If the hood needs to be disassembled, follow the instructions on the "Installation diagram" in the reverse order. A lever is enclosed for easier removal of the chimney - Miele DA 249 | Operating manual - Page 35
IMPORTANT SAFETY INSTRUCTIONS" to reduce the risk of personal injury. Follow all local building codes when installing the hood. Exhaust is used, the cross section must not be smaller than the cross section of the ventilation exhaust. - The ducting should be as short and straight as possible. - Use - Miele DA 249 | Operating manual - Page 36
flow direction of the flue. Never connect an exhaust hood to an active chimney, dryer vent, flue, or room venting ductwork. Seek professional for ducts 5" (125 mm) and 6" (150 mm) in diameter. When installing a condensate trap, ensure that it is positioned vertically and if possible directly above - Miele DA 249 | Operating manual - Page 37
found on the data plate (located behind the grease filters), match the household electrical supply before installing the hood. ^ Use only with ventilation hood cord-connection kits that have been investigated and found acceptable for use with this model hood. If there is any question concerning the - Miele DA 249 | Operating manual - Page 38
Technical data Maximum load 390 W Lighting 2 x 20 W Voltage 120 V Frequency 60 Hz Circuit rating 15 A Weight 49.6 lb (22.5 kg) 38 - Miele DA 249 | Operating manual - Page 39
39 - Miele DA 249 | Operating manual - Page 40
Alteration rights reserved / 2011 M.-Nr. 07 781 040 / 02 INFORMATION IS SUBJECT TO CHANGE. PLEASE REFER TO OUR WEBSITE TO OBTAIN THE MOST CURRENT PRODUCT SPECIFICATIONS, TECHNICAL & WARRANTY INFORMATION.
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
 |
 |
Operating and Installation
Instructions
Ventilation System
DA 249-4
To prevent accidents
and appliance damage,
read these instructions
before
installation or use.
M.-Nr. 07 781 040
en - US, CA