Miele F 1471 Vi Vi Freezer with Ice Dispenser (18 inch)
Miele F 1471 Vi Manual
View all Miele F 1471 Vi manuals
Add to My Manuals
Save this manual to your list of manuals |
Miele F 1471 Vi manual content summary:
- Miele F 1471 Vi | Vi Freezer with Ice Dispenser (18 inch) - Page 1
Product and Cut-out Dimensions F1471Vi 25" min. O 18" W 84" 17 3/4" 24" UNFARITOCANUCTSCTPEOAPMNTESL 83 1/2" - 85 3/8" E 9 1/2" Location Codes E - 5 foot - 120 Volt - 15 Amp 3-wire molded plug power supply connects lower left rear. O - - Miele F 1471 Vi | Vi Freezer with Ice Dispenser (18 inch) - Page 2
Product and Cut-out Dimensions F1471Vi Dispenser location Hinge 9 1/16" 14 1/2" 42 13/16" 1/2" - 2 3/8" Hinge Centerline Notes Notes • Centerpoint is 43 13/16" with typical 84" installation • All Installations must be - Miele F 1471 Vi | Vi Freezer with Ice Dispenser (18 inch) - Page 3
following manner: Width: 17 3/4" in all cases Thickness: Minimum 3/4" outside frame Height: Determined using the following calculation: Panel Height HOC Miele Fully Integrated Freezer Panel Height = HOC - TKH HOC = Total height of cabinet or side panel TKH = Toe-kick height Note: Finish back - Miele F 1471 Vi | Vi Freezer with Ice Dispenser (18 inch) - Page 4
0-3/4" 1" 1-1/4" 1-1/2" Door Swing 7/16" Door Swing 7 1/4" MAX 20 11/16" NOTE: Additional space needed depending on the thickness of front panels and handle used. Freezer units cannot be stop pinned at 90° NOTE: Additional space needed depending on the thickness of front panels and handle used
NOTE: Drawing is not to scale.
SPECIFICATION SHEETS
150209
Product and Cut-out Dimensions
F1471Vi
18"
25" min.
17 3/4"
83 1/2" - 85 3/8"
9 1/2"
24"
4 1/8"
84"
1 1/4"
E
UNIT ACCEPTS
A CUSTOM
FRONT PANEL
6 5/8" - 8 1/2"
2" - 8 3/8"
O
W
Notes
5 foot - 120 Volt - 15 Amp 3-wire molded plug power
supply connects lower left rear.
Standard NEMA 5-15 Outlet - locate less than 9" above
finished floor
1/4" flexible water line - tape to floor
E -
O -
W -
•
All Installations must be done in accordance with local codes
• Sides of adjoining cabinets should be filled (flush to frame) to
insure proper fit and finish
Location Codes