Miele HM 16-80 Operating manual
Miele HM 16-80 Manual
 |
View all Miele HM 16-80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Miele HM 16-80 manual content summary:
- Miele HM 16-80 | Operating manual - Page 1
Operating Instructions Rotary Iron HM 16-80 To prevent accidents and machine damage read these instructions before installation or use. en - US M.-Nr. 07 660 670 - Miele HM 16-80 | Operating manual - Page 2
INSTRUCTIONS 4 Guide to the Rotary Iron 7 Moving and folding the appliance 9 Transport strut 9 Before using for the first time 11 Preparing the work area 13 Preparing the laundry 13 Testing the finger guard 14 Steam setting 15 Filling the water reservoir 15 Emptying the water reservoir 16 - Miele HM 16-80 | Operating manual - Page 3
Contents Cleaning and care 28 Cleaning the water reservoir 28 Ironing cover 29 Frequently asked questions 32 After sales service 34 Electrical connection 35 Technical data 36 Help protect our environment 37 3 - Miele HM 16-80 | Operating manual - Page 4
or instruction by a responsible person. Technical and electrical safety ~ Before setting up the rotary iron, check for any visible damage. Do not install or use a damaged appliance. ~ A damaged appliance is dangerous. Turn off the rotary iron, unplug from the wall outlet and call Technical Service - Miele HM 16-80 | Operating manual - Page 5
may be possible for an installation in these applications. Please contact the nearest Miele Dealer or Miele Technical Service with specific requirements. Use ~ Be aware of loose fitting or hanging clothing when using the rotary iron. Items such as wide sleeves or apron strings could be wound in the - Miele HM 16-80 | Operating manual - Page 6
reservoir and steam line can damage the appliance. Accessories ~ Accessories should only be used if approved by Miele. If other parts are used, warranty, performance and product liability claims may be void. Regard the national and local codes and standards. SAVE THESE INSTRUCTIONS AND REVIEW THEM - Miele HM 16-80 | Operating manual - Page 7
l k j i h g Guide to the Rotary Iron m ab c d e f a Emergency release b Temperature selector c Control panel d Release catch e Power cord f Foot pedal switch g Ironing table h Laundry rod i Feed board j Roller k Heater plate l Finger guard m Water reservoir with cap 7 - Miele HM 16-80 | Operating manual - Page 8
Guide to the Rotary Iron Control panel g a f b e c d a Roller speed selector b On/Off indicator I-0 c On/Off button I-0 d Steam switch Q e Steam indicator Q f Temperature indicator oC g Water empty indicator a 8 - Miele HM 16-80 | Operating manual - Page 9
Moving and folding the appliance Transport strut Do not remove the transport strut until the rotary iron has been placed onto the four rollers. ^ Pull out the transport strut. Keep the strut in a safe place. It will need to be attached each time you transport the appliance. 9 - Miele HM 16-80 | Operating manual - Page 10
table and release the catch, located on the right-hand side at the back, underneath the ironing table. ^ Swing the top section of the rotary iron to the side until it clicks horizontally into position. Do not let go of the catch until you have finished swinging the top. ^ To prevent - Miele HM 16-80 | Operating manual - Page 11
Before using for the first time Power cord The power cord is wound behind the ironing table. ^ Unwind the cord. ,Do not insert the plug into the electrical socket yet. 11 - Miele HM 16-80 | Operating manual - Page 12
Before using for the first time A dust cover is placed on the roller for protection during shipping. ^ The adhesive film supplied with iron can now be placed around the temperature selector. ^ First remove the feed board by lifting it out of the right hand holder, then pull it - Miele HM 16-80 | Operating manual - Page 13
dampness (for operation without steam) The laundry needs to be sufficiently damp so that on the first pass through the rotary iron at the correct temperature pants) Cotton Linen Dampness for ironing wrap in a damp cloth to avoid water marks slightly damp to dry press under a damp cloth slightly - Miele HM 16-80 | Operating manual - Page 14
as easily as possible. Testing the finger guard The finger guard is a safety feature, and should be checked every time the rotary iron is used. ^ With the iron turned on, press the foot pedal all the way down. The heater plate comes down onto the rotating roller. Sorting Sort the laundry according - Miele HM 16-80 | Operating manual - Page 15
dry or nearly dry laundry items, the steam setting can be used. Ironing with and without steam If the laundry items are already damp, use the iron without steam. The steam setting is intended for pressing dry or nearly-dry laundry. Filling the water reservoir Only ever fill the water reservoir - Miele HM 16-80 | Operating manual - Page 16
Steam setting Emptying the water reservoir ,Do not attempt to empty the water reservoir unless the roller and water are both cool. Always empty the reservoir once you have finished ironing. This will help prevent damage spout. ^ After use, return the funnel to its place in the cord receptacle. 16 - Miele HM 16-80 | Operating manual - Page 17
on and off Use the I-0 button to turn the rotary iron on and off. To turn on ^ Press the button in. The indicator light comes on. Selecting the ironing temperature (operation without steam) The temperature selector is used to set the ironing temperature. The temperature range is marked by dots on - Miele HM 16-80 | Operating manual - Page 18
the ßß setting for Woolens, rather than using the cotton setting. Selecting the ironing temperature (operation with steam) ^ Turn the temperature selector to the ßßß setting for Cottons (hot iron). Turning on ^ Press the Q button. Once the desired roller temperature is reached, the indicator light - Miele HM 16-80 | Operating manual - Page 19
select a low roller speed when ironing layered or folded items, which may require more than one pass through the rotary iron to get them smooth and selector to the desired speed. - rest (heater plate is raised) - press - iron To iron: ^ Press the foot pedal all the way down to the floor. ,Do not - Miele HM 16-80 | Operating manual - Page 20
of the right-hand holder, then pull it outward toward the left of the roller. Laundry bar Ironed laundry can be hung over the swing out bar to avoid creasing. ,Take care not to press down on the bar when it is swung out, this could cause the rotary iron to tip over. 20 - Miele HM 16-80 | Operating manual - Page 21
"Steam". ^ Turn the temperature selector to I. ^ Unplug from the outlet. To store the rotary iron: ^ Allow the heater plate to cool. ^ Empty the water reservoir. ^ Fold the iron. - Articles with raised parts, such as buttons, should be ironed face down onto the roller, so that they are pressed into - Miele HM 16-80 | Operating manual - Page 22
event of a power failure, pull the emergency release lever up. If there is a power failure while the iron is in use, the heater play will stay pressed onto the roller. The item being ironed will be held there, and can become scorched. ^ Pull the emergency release lever up. The pressure is reduced - Miele HM 16-80 | Operating manual - Page 23
unironed edges together and place over the left end of the roller with the ironed middle section hanging over the edge to prevent creasing. Then pass both sides of the non ironed sections through the rotary iron. ^ If needed, make one more pass once the tablecloth is folded. ^ Lay the tablecloth - Miele HM 16-80 | Operating manual - Page 24
step. ^ If the open end has buttons, only pass it through the rotary iron if the buttons are heat resistant. If the duvet cover has buttons at the open end, iron the buttons first. Note: Only pass this end through the rotary iron if the buttons are heat-resistant. ^ Start the first run by carefully - Miele HM 16-80 | Operating manual - Page 25
button hem up to the armhole. ^ Now move the shirt out and iron past the armhole to the side seam. ^ Iron the button side inside out so the buttons are pressed into the cushioned surface of the roller. The collar is ironed on both sides using the left hand end of the roller. Stop - Miele HM 16-80 | Operating manual - Page 26
double-cuffs with one button hole placed over the other one and press lightly. ^ Smooth out the sleeve and place it on the edge of the roller. ^ Pull the shirt further down the roller and iron past the arm hole. ^ Iron the arm from the edge of the cuff to the underarm. Shift - Miele HM 16-80 | Operating manual - Page 27
one up to the bib, then over the bib and up to the waistband. ^ Then iron, in passes, up to the waistband, or iron crosswise. Let the bib hang over the left edge of the roller. Steam-pressing pants ^ Lay each pant leg separately on the roller. Let the upper part hang down over - Miele HM 16-80 | Operating manual - Page 28
steam, this may mean there are lime deposits in the water reservoir, caused by hard water. To remove these lime deposits, rinse the reservoir under tap water. ^ Unplug from the socket. ,Wait until the iron . See the section on "Steam" for instructions on filling and emptying the water reservoir. 28 - Miele HM 16-80 | Operating manual - Page 29
program (140°F [60°C]). If the cover looks worn and used, it can be easily replaced. Ironing covers are available at your Miele dealer or Miele. Cleaning and care Replacing the ironing cover ,The ironing cover should only be changed when the appliance is cold. ^ Remove the feed board. ^ Unwind - Miele HM 16-80 | Operating manual - Page 30
in the direction you iron (see arrow) until the retaining slot is at the bottom. ^ Turn the rotary iron on. When the iron is turned on, the ironing cover into the retaining slot with the side seams inside (upside down). Keep side ties hanging free and smooth out. 30 ^ Press the foot pedal and "iron - Miele HM 16-80 | Operating manual - Page 31
Once the roller has completed 3 or 4 revolutions and the end of the ironing cover is under the heater plate: ^ Turn the rotary iron off while keeping the foot pedal pressed down. The ironing cover is held firmly in place with the heater plate which is still lowered. Cleaning and care ^ Tighten the - Miele HM 16-80 | Operating manual - Page 32
plate with household cleaners or dishwasher detergent. The rotary iron cover is heavily soiled. Possible fault Solution Deposits Wash the iron cover with household detergent at 140°F (60°C) or replace with a new one. The heater plate does not press on the roller. Possible fault Solution The - Miele HM 16-80 | Operating manual - Page 33
is too low for Set the temperature selector to ßßß and steam production. wait until the display light comes on. No steam is being produced. The indicator light Q for "Steam" goes out while ironing, and the indicator a for "Water empty" is red. Possible fault Solution The water reservoir - Miele HM 16-80 | Operating manual - Page 34
cannot easily fix yourself, please contact the Miele Technical Service Department at the address on the back of this booklet. When contacting the Technical Service Department, please quote the model and consumption (wattage) The wiring diagram is located under the right side of the ironing table. 34 - Miele HM 16-80 | Operating manual - Page 35
electrical work should be carried out by a qualified electrician in accordance with local and national safety regulations. Do not connect the rotary iron to an extension cord. Extension cords do not guarantee the required safety of the appliance (e.g. danger of overheating). WARNING THIS APPLIANCE - Miele HM 16-80 | Operating manual - Page 36
Technical data Height Width Depth Weight Water reservoir capacity Voltage Rated load Minimum fuse rating 37 3/4" (folded 41 3/8") [95.9 (folded 105.2) cm] 38 3/4" (folded 19 5/8") [98.5 (folded 50) cm] 15" [38 cm] 86 lbs (39 kg) 1 ½ pints (800 ml) see data plate see data plate see data plate 36 - Miele HM 16-80 | Operating manual - Page 37
Help protect our environment Disposal of packing materials The cardboard box and packing materials are biodegradable and recyclable. Please recycle. Ensure that any plastic wrapping, bags, etc. are disposed of safely and kept out of the reach of children. Danger of suffocation! Disposal of an old - Miele HM 16-80 | Operating manual - Page 38
38 - Miele HM 16-80 | Operating manual - Page 39
39 - Miele HM 16-80 | Operating manual - Page 40
All rights reserved / 1213 M.-Nr. 07 660 670 / 01 INFORMATION IS SUBJECT TO CHANGE. PLEASE REFER TO OUR WEBSITE TO OBTAIN THE MOST CURRENT PRODUCT SPECIFICATIONS, TECHNICAL & WARRANTY INFORMATION.
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
 |
 |
Operating Instructions
Rotary Iron
HM 16-80
To prevent accidents
and machine damage
read these instructions
before
installation or use.
M.-Nr. 07 660 670
en - US