Motorola L903 User Guide - Page 25
Setting the flash time, Setting the area code, Registration - cordless
View all Motorola L903 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
NOTE If the pulse mode is selected, press TONE/* to switch from pulse to tone dialing temporarily when dialing out. After the call is ended, the dial mode will change back to pulse. 3.16 Setting the flash time The default flash time is 600MS. It is unlikely that you should need to change this setting unless advised to do so. 1. Press MENU and then VOL+ or REDIAL/VOL- to select SETUP BS. 2. Press MENU and then VOL+ or REDIAL/VOL- to select FLASH TIME. 3. Press MENU and then VOL+ or REDIAL/VOL- to the flash time you want. (8 options are available: 90, 100, 110, 250, 300, 400, 600 and 700MS) 4. Press MENU to save. 3.17 Setting the area code 1. Press MENU and then VOL+ or REDIAL/VOL- to select SETUP BS. 2. Press MENU and then VOL+ or REDIAL/VOL- to select AREA CODE. Using the Phone 3. Press MENU and enter the area code. 4. Press MENU to save. 3.18 Registration 3.18.1 Registering a handset Up to 5 handsets or wireless headsets can be registered to one base. The original handset is pre-registered to use. Additional handsets must be registered to the base before you can use them. To register an additional handset, 1. Press MENU and then VOL+ or REDIAL/VOL- to select SETUP HS. 2. Press MENU and then VOL+ or REDIAL/VOL- to select REGISTRATION. 3. Press MENU and then VOL+ or REDIAL/VOL- to select YES or NO. 4. Select YES and press MENU to enter the registration procedure as follows: 1. Press and hold FIND for 4 seconds on the base. 2. Place the unregistered cordless handset on the base or charger. 25