Motorola SBG6580 User Manual - Page 15

electrical outlet., Arrange the cables to prevent any safety hazards. - modem user guide

Get Motorola SBG6580 PDF manuals and user guides View all Motorola SBG6580 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

B Before drilling holes in the wall, check the structure for potential damage to water, gas, or electrical lines. 1. Position and secure the wall mounting template on the wall to mark the holes. There must be .10 inch (2.5 mm) between the wall and underside of the screw head. 2. Select an appropriate depth and diameter to drill the holes to a depth of at least 1½ inches (3.8 cm). Note: The installer must determine the depth of the hole, the necessary hardware and must be careful to select the appropriate depth and diameter. 3. Reconnect the coaxial and Ethernet (or USB) cables after mounting the gateway. 4. Re-plug the power cord into the +12VDC Power connector on the gateway and the electrical outlet. 5. Arrange the cables to prevent any safety hazards. 6. Verify the gateway is still securely attached to the wall. Installing the Modem • Motorola SURFboard • User Guide 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
B
Installing the Modem •
Motorola SURFboard • User Guide
7
Before drilling holes in the wall, check the structure for potential damage to water, gas,
or electrical lines.
1.
Position and secure the wall mounting template on the wall to mark the holes.
There must be .10 inch (2.5 mm) between the wall and underside of the screw head.
2.
Select an appropriate depth and diameter to drill the holes to a depth of at least 1½
inches (3.8 cm).
Note
: The installer must determine the depth of the hole, the necessary hardware
and must be careful to select the appropriate depth and diameter.
3.
Reconnect the coaxial and Ethernet (or USB) cables after mounting the gateway.
4.
Re-plug the power cord into the +12VDC Power connector on the gateway and the
electrical outlet.
5.
Arrange the cables to prevent any safety hazards.
6.
Verify the gateway is still securely attached to the wall.