NEC E551 E551 : WMK-E551 accessory guide
NEC E551 Manual
 |
UPC - 805736034455
View all NEC E551 manuals
Add to My Manuals
Save this manual to your list of manuals |
NEC E551 manual content summary:
- NEC E551 | E551 : WMK-E551 accessory guide - Page 1
Installation and Assembly - Flat Screen Wall NEC DISPLAY SOLUTIONS OF AMERICA, INC. Mount for NEC model: E551 Model: WMK-E551 This product is intended for use with UL Listed products and must be installed by a R qualified professional installer. Maximum UL Load Capacity: 150 Ib (68 - NEC E551 | E551 : WMK-E551 accessory guide - Page 2
construction, and fully understands these instructions. • Make sure that the supporting surface will safely support the combined load of the equipment Service for Peerless accessory kit for metal studs. (not evaluated by UL) Contact Customer Service (not evaluated by UL) Contact Customer Service. - NEC E551 | E551 : WMK-E551 accessory guide - Page 3
Tools Needed for Assembly • stud finder ("edge to edge" stud finder is recommended) • phillips screwdriver • drill • 5/16" bit for concrete and cinder block wall • 5/32" bit for wood stud wall • level Accessories • 4 piece Metal Stud Fastener Kit (ACC 415) (Not UL listed) Before you begin, make - NEC E551 | E551 : WMK-E551 accessory guide - Page 4
Installation to Double Wood Stud Wall WARNING • Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached hardware and components. • Tighten wood screws so that wall plate is firmly attached, but do not - NEC E551 | E551 : WMK-E551 accessory guide - Page 5
minimum from the side of the block. Cinder block must meet ASTM C-90 specifications. It is suggested that a standard electric drill on slow setting is used not hold concrete anchor. • Make sure that the supporting surface will safely support the combined load of the equipment and all attached - NEC E551 | E551 : WMK-E551 accessory guide - Page 6
not tightly secured, damage may occur to screen or product may fail. 2 To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen. Place screen face side down. If screen has knobs on the back, remove them to allow the tilt brackets to - NEC E551 | E551 : WMK-E551 accessory guide - Page 7
& C) onto wall plate (A) and swing screen down as shown in fig. 3.1. Tilt bracket hooks must fully engage wall plate. Using phillips screw driver or security allen wrench (F), turn safety/security screws on tilt brackets (B & C) clockwise till screw tip securely contacts wall plate as shown in cross
-
1 -
2 -
3 -
4 -
5 -
6 -
7
 |
 |
ISSUED: 07-28-10
SHEET #: 125-9132-1
Maximum UL Load Capacity: 150 Ib (68 Kg)
±²³´µ¶·¸¹º»´·¼¹½¾¶¼±·´¼¿´ºÀ²Á¶³ºÂ´¶±³Ã
Model:
WMK-E551
Installation and Assembly - Flat Screen Wall
Mount for NEC model: E551
±
This product is intended for use with UL
Listed products and must be installed by a
qualified professional installer.