NEC LCD19WV User Manual - Page 11
OSD Message - - osd
UPC - 805736020038
View all NEC LCD19WV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Controls -continued Main Menu Item OSD Setup Main Menu Icon Sub Menu Item Sub Menu Icon Description H.Position Adjust the Horizontal position of the OSD. V.Position Adjust the Vertical position of the OSD. Language Information OSD Timeout Adjust the OSD timeout. Language N/A Set OSD language. Information N/A Show the resolution, H/V frequency, Serial No., DDC/CI Enable/Disable and input port of current input timing. Reset Yes N/A Clear each old status of Auto-configuration. No N/A Do not execute reset, return to main menu. Exit N/A N/A Exit OSD OSD Message Auto Config Please Wait: If User presses Hot-Key "Auto," a message will appear, and the monitor will do the auto configuration function. Input Not Supported: this message will appear when the H sync frequency, V sync frequency or Resolution is out of the monitor's support range. Cable Not Connected: this message will appear when the video cable is not connected. No signal: this message will appear when the video cable is connected but there is no active signal input. After 5 seconds the monitor will enter Power-Saving mode. This message is located in the position setting "OSD Setup." OSD Locked: When the OSD is locked, hold down the "Menu" key and press the "Power" key once to turn on the monitor. The OSD will be locked, and this message will appear. When the OSD is locked, only "Power" key function is still working, and if any other key is pressed this message will remain. When the OSD is locked, hold down the "Menu" key and press the "Power" key once to turn on the monitor. The OSD will be unlocked and does not show the message. This message location is in the position setting "OSD Setup" item. DDCCI Disable/Enable: When DDCCI enable, press "Auto" key. After 5 seconds the monitor will show the "DDCCI Disable" message. When DDCCI disable, press "Auto" key. After 5 seconds the monitor will show the "DDCCI Enable" message. This message is located in the position setting in "OSD Setup" item. 9